Replacing a solenoid Frequently fixes a starter concern.
A Toyota owner may decide to moderate the unabridged starter whether the solenoid needs replacing. They engage in so due to the starter has to be taken absent to remove the solenoid. Fair-minded since the solenoid is dangerous, nevertheless, doesn't close you gain to incur the value of replacing the complete starter. After all, replacing the solenoid by oneself income you aloof gain to remove two also bolts. That's not a group of commission for the extent of capital you can save by not replacing the starter Engine, also.
Instructions
1. Dwelling the Toyota on a fix of front point ramps and secure the emergency brake. Domicile a revolve chock at the end the rear tire to prevent the Toyota from rolling backward while you are under it.
2. Disconnect the absent battery cable from the battery. Disconnect the acceptable battery cable from the battery. Wrap both connectors with shop towels to prevent them from accidentally touching the battery terminals.
3. Place the starter. On side-mounted engines, the starter is latest the front half-shaft axle on the passenger side. On criterion front-mounted engines, the starter is connected to the driver-side lower half of the engine.
4. Remove the wire-retaining stone from the comprehensive, melanoid wire that secures the wire to the starter casing. Practice a boxed wrench to remove the bolt.
5. Separate the wiring harness from the starter solenoid.11. Secure the large black wire to the threaded post on the starter and bolt it into place with the original wire-retaining nut.12.
7. Remove the two bolts that secure the starter solenoid to the starter. Pull the solenoid off the starter. Use a boxed wrench to remove the bolts.
8. Place the new solenoid onto the starter and bolt it into place.
9. Slide the gear located on the end of the starter into the engine. Line up the bolt holes and secure the starter to the engine with the original bolts.
10. Reconnect the wiring harness to the starter solenoid. Push on it until it clicks into place.
Squeeze the release tab in the center of the harness connector and pull the connector off the solenoid.6. Remove the two bolts that secure the starter to the engine block and pull the starter out of the engine. Use a boxed wrench or socket set to remove the bolts.
Reconnect the positive battery cable and then the negative battery cable.
