Starter Relay
The starter relay on your vehicle acts as the intermediary between the ignition switch and the starter Engine. When you turn the ignition important, a microscopic contemporary is sent to the relay that causes the relay to shut the method within it to supply capacity to the starter. Whether the starter relay fails, you won’t be able to begin the engine. Damage to the starter relay Frequently happens from a wick gift connexion on the starter that causes it to short method. A nonworking relay cannot be dismantled for repair; you Testament hold to install a fresh one in composition to begin the engine. You can alternate the starter relay deserved Homewards; with a meagre tools, it should catching 10 minutes to discharge.
Instructions
1. Up thrust the hood on your vehicle and then place the battery.
2. Exercise a socket wrench to remove the livid wire from the battery. It Testament be identified with a minus (-) symbol after to its publicize.
3. Wrap electrical tape sorrounding the metal terminal extreme of the cable until no metal is visible and then place the cable down on the side of the battery instance.
4. Establish the Ability Distribution Centre (PDC) within the engine compartment. The PDC contains your vehicle’s better fuses and relays. It usually mounts on the correct, or driver’s side, of the engine compartment and has a square nigrous plastic incorporate over its relays and fuses. Whether you have trouble locating it, check your owner’s manual under "FUSES" or "RELAYS."
5. Check the top of the PDC cover for relay and fuse mounting locations. Some vehicles have this information on the top of the cover and some have the information on the inside of the cover once you remove it. If you don’t see anything on the top of the PDC cover, remove it by pushing in the plastic tabs on the sides of the cover and then lifting the cover straight off.
6. Read the information on the PDC cover. The fuses will look like rectangles and have individual names next to them, according to what they power. The relays will be shaped like squares and have names in the center of each square to let you know what they power extremely.
7. Locate the relay square on the PDC cover that says "Starter Relay" at its center. Identify the corresponding relay mounted in the PDC.
10. Reinstall the cover for the power distribution center and then remove the tape from the battery cable’s terminal.11. Connect the cable back to the battery and tighten its bolt until snug.
9. Install the new starter relay by hand. Match up the metal or copper blades at the bottom of the relay with their correct slot in the PDC. Then place the new starter relay in position and gently push down on it until it seats itself completely back into the PDC.
8. Remove the starter relay by placing a pair of relay-puller pliers around the housing of the relay and then pulling the starter relay straight out vertically. Do not twist or turn the relay because it is not screwed in.
Set your 3/8-inch drive torque wrench to 12 ft-lbs. and then completely secure the battery cable in place.
12. Start the engine to check the repair.
