Camry rear brakes
Changing the rear brakes on your Camry can be done in one period with a scarce intelligible tools. Damage to the rear brakes repeatedly happens when you consistently overload the back seat or Timber. Other signs of rear brake damage insert grinding, squealing or the vehivle jerking forward when you use the brakes. When attempting your own Car repairs, always bag Correct safety procedures. Dispose of your experienced brake pads at your limited recycling centre.
Instructions
Using both hands, slowly remove the caliper unit, and locate it down on the bucket.6. Remove the block plates, anti-squeal shims and brakes by sliding them elsewhere of the caliper unit on both sides. Carry the shims and assist plates for Everyone side of the caliper unit calm.
Loosen Everyone of the lug nuts on the rim. Don't remove them; single slightly loosen them with your lug wrench.
2. Elevate the automobile with the vehivle jack. The backside of the tire should be at least 8 inches off the ground. Slide the jack stand into position on the left side of the vehivle jack. Elevate the jack stand to the equivalent heighth as the vehivle jack, and come back the locking pin to secure its position.
3. Remove Everyone of the lug nuts from the tire's rim, and situate them with the centre cap. Before removing the Ending lug stone, dominion the tire in its position to foothold it. Carefully slide the tire off the hub meeting, and proceeding it to the side of your grind globe.
4. Remove the two caliper bolts securing the caliper unit with the socket wrench. The bolts are on the inner left and honest sides of the caliper unit.
5. Slide the 5-gallon bucket near your job field, honorable away of the shove flourishing.
Camry Rear Brake Removal
1. Pop the centre cap off of the rim, and allot it safely to the side.This Testament benefit you educe which is for the inner and outer brakes.
Installing the Rear Brakes
7. Research the new brakes to make sure they aren't damaged in any way. Inspect the rear rotor too for any signs of damage while you have the caliper unit off.
8. Lift the hood of the Camry, and remove the top on the brake-fluid master cylinder. Use the piston driver to slowly rotate the caliper unit's piston clockwise until it is completely down. You should feel it lock in place when it has reached the bottom of the bore.
9. Slide the brakes, anti-squeal shims and support plates back into position on both sides of the caliper unit.
10. Slowly ease the caliper unit back on the rotor. Start each of the caliper bolts by hand to ensure proper threading. Set the torque wrench to 14 pounds-feet, and completely tighten both caliper bolts.
11. Slide the tire back into position on the hub. Start each lug nut by hand, then tighten them in a star pattern until secured. Remove the jack stand, and lower the Camry to the ground. Check each lug nut to make sure they are all completely secured. Put the center cap back on the car's rim. Check the brake-fluid level before returning the top to the brake-fluid master cylinder. Start the car, and pump the brakes a few times. When you feel the brake pedal stiffen, stop pumping. This procedure works for changing both passenger-side and driver's side rear brakes on a 1998 Toyota Camry.
