Some recoils are a back-up action for an electric starter on Polaris watercraft, snowmobiles and four-wheelers. District the repercussions subsume so the inside pulley is facing up on your orbit.4. Establish the ancient leash or depression where the rope's lash seats into the pulley.
1. Remove the repercussions embrace from the engine by removing the attachment bolts on the incorporate.
2. Shorten a group of repercussions rope of the twin proportions and excellence, using a scissors . Employment the elderly pull rope to drive the Correct length. Heat one confine of the nylon rope with a lighter to melt it. Dip your thumb and forefinger into inundate and quickly pinch the location of the melted rope to formation a smooth rounded aim while it's yet Boiling. Repeat on the other extremity of the rope. This prevents the rope from fraying.
3. The pull rope, or repercussions action, used on Polaris snowmobiles, watercraft and four-wheelers is specious of nylon rope and is manufactured to ultimate a spread out bout. They normally fail in that the mechanism used to attach them to the T-handle or kickback pulley intersect into the rope and caused it to fray. When replacing the rope, be positive to call a exceptional merit nylon rope fabricated largely for recoils.
Instructions
Pull the old knot from the pulley if it still remains. Tie a double knot close to one end of the new rope.
5. Hold the center pulley of the recoil so it can't turn. Rotate the recoil cover in the direction that tightens the recoil spring under the pulley, while holding the center pulley still. The cover is normally rotated in the opposite direction that the pulley turns when the pull rope is pulled.
6. Rotate the cover until you feel the spring tighten, then back it off until the knot depression in the pulley aligns with the exit hole of the recoil cover.
7. Feed the rope through the knot depression hole in the pulley and out the exit hole in the cover while still holding the cover and pulley rigid. When the rope exits the cover, feed it through the recoil T-handle and tie a knot or double knot to hold it. Pull the entire rope out of the recoil to seat the knot in the pulley's depression. Allow the spring to turn the pulley slowly as it winds the cord back into the pulley.
8. Pull the newly installed recoil rope as you would if you were going to start your Polaris. The recoil should pull out smoothly and recoil back into the cover with the spring.
9. Align the recoil pulley to the crankshaft of the Polaris and reinstall the cover. Reattach the cover bolts and tighten.
