For as distant as there retain been muscle cars, there has been a hope for by some owners to compose their cars louder and augmented almighty. One adjustment that accomplishes both of these tasks is to install a Flowmaster exhaust system on your vehicle. The reduced exhaust backpressure associated with this installation Testament hoist your engine's horsepower slightly, further as ante up your tool a classic muscle motorcar sound. The Flowmaster exhaust method can be installed on your vehicle in even-handed a hardly any hours with general mechanic's tools.
Instructions
1. Back your vehicle onto a locate of automobile ramps and operate the parking brake. Chock the front wheels to prevent any unwanted movement.
2. Crawl under the vehicle and operate penetrating fluid to the Trimmings on your current exhaust system To admit for easier Emigration. Confess the fluid to drudgery in for indefinite minutes be continuing.
3. Don safety goggles and gloves for Safeguard against falling rust particles and sharp metal edges. Loosen the conduit clamps on the exhaust method by turning the clamp nuts in a counterclockwise line with an adjustable wrench.
Save these parts for the installation of the Flowmaster system. Discard the old exhaust system..5. Install the rubber isolators and hangers to the new Flowmaster exhaust system with the original bolts turned with an adjustable wrench in a clockwise direction. Application a twisting movement on the exhaust pipes to seperate them from the head pipes if necessary. Lower the exhaust system from the vehicle. Remove the rubber isolators and pipe hangers from the mufflers with an adjustable wrench turned in a counterclockwise direction.4. Remove the bolts from the exhaust hangers at the rear of the vehivle with an adjustable wrench turned in a counterclockwise succession. Endeavor the exhaust method In relation to the back of the automobile to seperate it from the exhaust mind pipes.
Note that the hangers will install to your Flowmaster system in the same fashion as your stock exhaust.
6. Place the Flowmaster system under your vehicle with the mufflers facing the rear. Raise the system up and fit the front of the Flowmaster pipes into the vehicle's head pipes until they are fully seated. Attach the pipe hangers to the bottom of the car using the original mounting holes and bolts tightened with an adjustable wrench in a clockwise direction. Install the pipe clamps supplied with your Flowmaster kit onto the joint where the pipes meet the car's original head pipes. Tighten the clamps with an adjustable wrench in a clockwise direction.
7. Remove the wheel chocks, release the parking brake, and carefully drive the car off of the ramps.
