Liking every other type of clear, brake lights don't endure forever. Replacing them on an machine such as a Ford can seem daunting. Happily brake lights, unlike brakes themselves, can be replaced on Fords quickly and easily.
Instructions
Replace the Brake Light in a Ford Car
1. Fix the brake lustrous meeting. This is inaugurate in the Timber of the machine, and you Testament essential to pull aside the lining of the Timber to access it.
2. Loosen and remove the three nuts that connect the brake light meeting to the rear lantern mounting studs.
3. Remove the brake glowing meeting by pulling it absent of the Ford entity. Avoid scraping it against the sides, as it Testament damage the gloss.
4. Grasp the light bulb socket and twist it counterclockwise until the socket can be removed from the meeting. Be certain not to apply Exorbitant fury when twisting the socket to avoid defective it or breaking the lucent bulb.
5. Pull the shine bulb elsewhere of the brake flash socket. The brake flashing bulb for a Ford does not acquire a thread on its representation, so it does not want career twisted gone.
6. Moderate the brilliance bulb with one of the corresponding wattage. Push it in gently however firmly.
7. Twist the socket back into the brake glossy meeting. The socket has an indexing tab on it that must be lined up with the alike slot on the brake aglow meeting, and turning the socket clockwise Testament lock it into position.
8. Change the brake glowing meeting in its housing. Community the nuts onto the mounting studs and tighten them. Convert the trunk lining and close the trunk.
9. Understand that each Ford car has subtle differences. Before removing the brake light assembly on each car, take the time to inspect how it is held in place and what tools will be required to remove it.
Replace Brake Lights on a Ford Pickup Truck
10. Open the tailgate of the pickup truck. This will reveal the compartments in which the brake light assemblies are stored, each of which is kept in place by two screws.
11. Loosen and remove the screws keeping the brake light assembly in place. Put the screws in a safe area to prevent loss.
12. Pull out the brake light assembly.15. Place the socket into the brake light assembly. Figure out line up the socket tab with the corresponding slot in the brake light assembly and then twist it clockwise until the socket locks in place.16.
Since the light bulb does not have threads, unscrewing it is not necessary.
14. Replace the light bulb with one that has the same wattage. Push it into the socket firmly but without using excessive force.
Be sure to avoid pulling the assembly out at an angle in order to avoid scratching the paint, an error which will be more obvious on a pickup truck than in the trunk of a car.13. Twist the light bulb socket located in the brake light assembly counterclockwise in order to remove it. Then grasp the light bulb and pull it out.
Replace the brake light assembly in the pickup truck body. Insert the screws into their connecting holes and tighten them.
17.Close the tailgate.
