Convert your Dodge's fuel pump.
Stand the rear of the vehicle using a floor jack and safely ease it on two jack stands.8. Disconnect the vapour column from the Evaporative Emissions (EVAP) canister tube whether your specific Dodge imitation is equipped with one beside to the fuel tank.9. Own your fuel pump replacement ready, provided imaginable, and accomplish firm you admit the essential tools.
Instructions
Relieve the Fuel System Pressure
1. Allot the fuel pump relay. Depending on your specific vehicle, this might be in a energy distribution centre inside the engine compartment or underneath the dashboard.
2. Unplug the fuel pump relay.
3. Begin the engine and let it sluggish until it stalls. Turn the ignition switch "off."
4. Re-install the fuel pump relay.
Remove the Fuel Pump
5. Bleed the fuel vehicle, provided essential, into an approved fuel container using a ability siphon pump.
6. Disconnect the coal, contravening battery cable.
7.The electric fuel pump on your Dodge fuel injection example is mounted inside the fuel receptacle. It is chip of the fuel module meeting. To exchange the pump you exigency to lower the vat, maybe with the benefit of an assistant.
Remove the EVAP canister using a wrench or ratchet and socket, if necessary, to make room to lower the fuel tank.
10. Disconnect the fuel line from the pump assembly by depressing the quick-connect retainer tabs and pull the line connector from the fitting.
11. Unplug the fuel pump electrical connector form the pump assembly.
12. Disconnect the vent tube and any other line connected to the pump assembly.
13. Support the fuel tank with a floor jack and remove the tank strap bolts using a ratchet, ratchet extension and socket.
14. Lower the tank just enough to get access to the fuel pump assembly.
15. Remove the fuel pump assembly by disconnecting the module locknut using a spanner wrench or similar tool.
16. Lift the fuel pump assembly off the fuel tank and discard the O-ring seal.
Install the Fuel Pump
17.Remove the old pump from the assembly and install the new one.
18. Install the fuel pump assembly on the tank along with a new O-ring seal. Ailing the tab on the underside of the fuel-pump module flange with the notch on the fuel tank and tight the locknut.
19. Lift the tank and install the tank straps and mounting bolts.
20. Connect the vent tube if equipped.
21. Plug the fuel pump electrical connector to the fuel pump assembly.
22. Connect the fuel line to the fuel pump and any other lines you disconnected from the assembly on your particular Dodge model.
23. Install and connect the EVAP canister if you had to remove it.
24. Lower the vehicle.
25. Connect the black, negative battery cable.
