Hone the cylinders on your Nissan Sentra to install latest piston rings.
Then result this procedure to ready the cylinders for engine reassembly.
Instructions
1.Hone the cylinder walls on your Nissan Sentra engine whether you path to install cutting edge piston rings. Cylinder honing Testament split the glaze or the Rugged surface whether you sent the block for cylinder humdrum. Choose the hold water honing stone grit for the activity according to the piston bell manufacturer.Mount the engine block on an engine stand or benefit the top of a sturdy workbench and build firm the block is completely Disinfected before you commence.
2. Install the leading bearing caps on the block and tighten the bolts to the torque recommended for your specific Nissan Sentra representation. You can catch this earful on your vehicle avail instruction; scrutinize the Gratuity cut at the backside for amassed break.
3. Install the hone in the competency drill and place on your safety goggles. Compress the stones by handwriting to avoid scratching the cylinder walls and encompass the hone into the cylinder.
4. Combine Identical parts of original 20W Engine oil and kerosene in a Disinfected container and appropriateness it to lubricate the cylinder wall you Testament be honing basic. Keep the cylinder well lubricated as you hone the cylinder.
5. Turn on the drill and keep it at a low speed while always moving the drill up and down. Your goal is to produce a crosshatch pattern on the cylinder wall with the lines crossing at an angle close to 60 degrees. Make sure to keep the cylinder wall well lubricated
6. Keep the hone moving up and down. When you are finished or want to stop to lubricate the cylinder wall, release the drill switch but keep the hone moving until the drill comes to a complete stop; then compress the hone with your hand and withdraw the hone.
7. Move on to the next cylinder, following steps 4 through 6 until you hone all the cylinders; then wash the entire engine block using warm water and soap to remove all the grit produced during the honing process. Dampen a clean shop rag with clean motor oil and wipe the cylinder walls with the rag. When there's no gray residue left on the rag, the cylinder walls are cleaned.
8. Let the engine block dry completely, apply a coat of rust preventive oil to the block and wrap it in a large, trash plastic bag to keep dirt off the block and ready for assembly.
