Modify Honda Accord Airbags
Most Honda Accord cars come guideline with Chauffeur and passenger air bags. Whether you commitment to transform one or both air bags, you must convenience supreme caution when handling them due to their touchy essentiality. Always educe that the Supplemental Restraint Development (the air bags) is apart one of the automobile's safety features and is not meant to change the seat belts.
Instructions
Removing the Air Bags
1. Disconnect both battery cables, starting with the dissension cable. Wait at least three minutes for the air bag method to lose its potential.
2. Remove the lower access encompass to the steering shove by removing its Phillips screws and carefully pulling the panel to Proceeds the three upper clips.6. Unscrew the passenger air bag retaining screws and slide the air bag downward elsewhere of its mount. Provided it has mounting guides and they come elsewhere with the bag, install the mounting guides back into the mounting frame.
You may compulsion to turn the circle to access the screws on either side, so it helps To possess the automobile in impartial. Carefully lift the air bag off the spin.
4. Detach either the glove box or the dashboard Element on the passenger side by removing the Phillips screws. You Testament must to unbolted the glove box and Proceeds the two limiting stops on both sides before removing the screws.
5. Disconnect the passenger air bag connector, which may be a two or three-plug connector. Whether it is a three-pin, set the blooming shorting connector and connect the three-prong connector to it after disconnecting it from the air bag.
Unplug the electrical connector for the Chauffeur's side air bag, which is a two-pin connector extreme the access subsume.3. Remove the mounting screws for the air bag on the steering border.
Installing New Air Bags
7. Mount the new air bags in place either on the steering wheel or within the mounting frame on the passenger side. Install the mounting screws and re-connect the electrical connector.
8. Re-install the glove box or trim panels you removed to access the electrical connectors.
9. Check to see if the air bags are properly installed along with the seat belt tensioners if equipped, then reconnect the battery, starting with the positive cable. Enter the security code for the stereo if needed.
10. Turn the ignition to the on position without starting the car and look for the "SRS" indicator light to come on for six seconds. If it stays on longer or doesn't come on at all, you seed To possess the restraint system checked for any faults.
