Adjacent models of the Toyota Celica had a 1.8L four-cylinder engine. While this engine isn't that contrastive from other Toyota four-cylinders, it does thirst for additional bullwork when replacing the thermostat. The Toyota Celica's oil filter must be removed prior to accessing the thermostat. Whether your cooling development isn't properly cooling your engine, you may admit a sticking or defective thermostat, which Testament demand replacement. You can complete it Homewards, if you are quite experienced in Car repair and enjoy the basic tools.
Instructions
1. Shut the engine off and let it chilly down for 30 to 45 minutes. Engine components and coolant bias immoderately ardent (approximately 200 degrees F) and can originate severe burns.
2. Unhook the contradiction battery cable and position it absent of the means, so it doesn't compose contact with the publicize.
3. Remove the plastic engine shroud from underneath the Celica. Position the void pan underneath the radiator void plug. Remove the remove plug and authorize the coolant to completely empty elsewhere.
Clean the mount with a dry rag.8. Place the new gasket on the new thermostat.
5. Loosen the clamp on the lower radiator hose and pull the hose absent from the soak inlet housing. The hose will likely have a small amount of coolant in it; let it drain into the container.
6. Remove the two bolts from the thermostat housing. Pull the housing away and set it aside. Pay attention to the position of the thermostat valve. The new thermostat needs to be in the same position (facing the bolt stud).
7. Pull the old thermostat off and remove the gasket from the mount. Discard the gasket.4. Unhook the engine temperature switch from the flood inlet housing near the thermostat. Remove the oil filter to access the thermostat. Employ a Correct oil filter wrench.
Insert the thermostat into the mount. Make sure the valve is facing the stud.
9. Replace the housing and tighten the bolts. Hook up the lower radiator hose and tighten the clamp.
10. Reattach the engine temperature switch and replace the oil filter. Tighten the oil filter by hand; do not use the wrench.
11. Reconnect the negative battery cable. Replace the radiator drain plug. Replenish the cooling system.
12. Crank the engine and check for leaks. Closely monitor the engine operating temperature to make sure its within the acceptable range.
