Convert a Rear Axle Seal on a Toyota Tacoma
The work of the rear axle shaft seal is to clasp the axle meeting firmly to the axle housing. Provided the seal is damaged, you may detect oil leaking from the connexion aim at the axle and axle housing. Provided oil is leaking, the axle Testament soon lose its lubrication and suffer deadpan damage. Whether you blink the poser and the axle is damaged, the faculty becomes all the more else hard and costly. You Testament corner to remove the rear brake meeting to access the axle and seal.
Instructions
Disassembly
1. Loosen the lug nuts on the rear revolve of the manage shaft seal you extremity to change. Lift the rear of the Motor lorry with a jack and abutment the Motor lorry on jack stands.
2. Remove the lug nuts with a lug wrench and catch off the revolve.
3. Pull off the brake drum. Whether it is stuck on, tap the drum along its edges with a mallet and spray penetrating oil encompassing the revolve studs. Spray the comprehensive brake meeting with brake cleaner to remove any harmful brake dust.
12. Install the brake line hose and tighten it with the wrench.13. Appliance a hold-down spring item to remove the hold-down spring from the rear shoe. Situate the factor over the spring, rotate it 1/4-turn counterclockwise and Proceeds the part to remove the spring. Remove the rear shoe by disengaging the lower anchor spring from the shoe.
5. Application the hold-down spring baggage to remove the hold-down spring from the front shoe. Employment a duo of pliers or a petty screwdriver to detach and remove the adjusting lever spring attached to the shoe. Remove the adjusting lever. Pull the parking brake lever elsewhere of its bracket near the adjuster lever to Proceeds it from the shove meeting. Remove the brake shoe.
6. Unscrew the brake borderline from the top inner quantity of the turn meeting with a wrench.
7. Convenience a socket to remove the four backing plate mounting bolt nuts. These are arranged in a square replica encompassing the axle, behind the backing plate.
8. Pull the axle shaft out of the axle housing. Remove the O-ring from the axle housing and discard it.
9. Use a seal removal tool or large flat head screwdriver to pry out the axle shaft oil seal from the axle housing.
Reassembly
10. Use the seal installer or large socket to drive the new seal into the axle housing. Tap it into place with the mallet until it is seated flush with the axle housing. Lubricate the outer edge of the seal with multi-purpose grease. Place the new O-ring onto the seal and coat it lightly with grease.
11. Coat the axle with oil and re-insert it into the axle housing. Replace the four backing plate retainer nuts.
4. Proceeds the give back spring from the top side of the shoe reverse the parking brake cable. This is the rear shoe. Bag a screwdriver to pry the spring absent of the gap.
Reassemble the brakes in the reverse order of disassembly. Replace the front brake shoe. Replace the emergency brake into its retainer.
14. Connect the anchor spring to the bottom of the two shoes. Rotate the rear shoe into place. Attach both hold-down pins and springs into place with the hold-down spring tool.
15. Connect the adjuster and the return spring at the top of the brake shoes.
16. Replace the brake drum over the brake assembly. Remount the wheel and reinstall the lug nuts. Lower the vehicle and tighten the lug nuts with the lug wrench.
17.Drive the vehicle forward and backwards, frequently pressing the brake pedal. This will allow the rear brake self-adjusters to adjust the brakes.
