2003 Ford
Taurus Inundate Pump Directions
The saturate pump on the 2003 Ford Taurus is an integral baggage of the engine cooling step. The hose pump pulls coolant from the radiator and delivers it to the engine. When it fails, your engine is not properly cooled, and you risk malicious it, so it is constitutive that you convert the aqua pump as soon as it fails.2. Abode a bucket under the front of the vehicle below the radiator plug. Pull the plug to withdraw the coolant from the machine.
Many times, the baptize pump Testament sieze, and the region Testament gash, indicating that you longing to alter the pump.
Instructions
1. Stadium your 2003 Ford Taurus on a equable surface then emptied the hood to access the engine compartment.3. Turn the pulley tensioner on the damp pump counterclockwise with a 1/2-inch coerce socket to loosen the serpentine girth. The baptize pump is located on the left side of the engine.
4. Employ the 1/2-inch guide socket to turn the bolt on the roll restrictor counterclockwise until it is loose Sufficiently so that you can act the roll restrictor outside of the pathway of the H2O pump. The roll restrictor is a far-reaching brace that is bite of the engine mount near the imbue pump.
5. Message the zone routing diagram for the serpentine cummerbund on the top of the fan shroud. Whether the diagram has worn off, sketch one absent so you Testament be able to properly reattach it to all the pulleys once you include installed the current irrigate pump.
6. Remove the serpentine girth from aloof the inundate pump pulley. If you loosened the pulley tensioner enough, you should be able to remove the belt without any additional tools.
7. Turn the nut and bolt counterclockwise with the 1/2-inch drive socket to remove the support bracket.
8. Remove the water inlet hose leading from the water pump to the radiator.
9. Detach the sensor from the electrical connector. The sensor is a series of wires that connect to the water pump.
10. Remove the water pump from the engine compartment.
11. Install the water inlet hose onto the new water pump.
12. Mount the new water pump into the engine compartment.
13. Replace the bolt in the support bracket and turn it clockwise to tighten it.
14. Insert the electrical connection plug into the new water pump.
15. Move the roll restrictor into place and use the 1/2-inch drive socket to tighten the bolt.
16. Place the serpentine belt over the water pump pulley. Refer to the diagram on the fan shroud or the diagram you drew to verify the belt is going over all the pulleys in the correct order.
17.Use a pry bar to pull on the water pump while you turn the tensioner pulley clockwise to secure the assembly, placing tension on the belt.
18. Fill the radiator with coolant. Leave the cap off of the radiator, while you start the vehicle, To admit any air in the cooling lines to escape.
