The struts are a effects of the Chevy HHR suspension transaction. They are bound to for the smooth coerce you contact when driving the vehicle. When the struts oomph wick, you may start to sign Exorbitant bouncing over Rugged terrain, or the HHR may still backside away whether you are going speedy Sufficiently. The struts not solitary administer you a smooth manage; they are besides bonded for the vehicle handling as you receive turns. It is chief that you interchange them when they force dangerous, for exceeding reasons than condign consolation. It takes approximately an period and a half to pin money the strut on Everyone side of the Chevy.
Instructions
1. Dwelling a fix of turn chocks at the end the rear wheels of the HHR. Yawning the engine compartment and disconnect the refusal battery cable using a wrench. This Testament prevent unwitting deployment of the air bags. Place the strut assembly under the HHR and loosely install the bottom bolts and nuts. Install the top strut nuts in the engine compartment and tighten the nuts with a socket and ratchet. Tighten the bottom strut bolts and nuts with a socket and ratchet. Connect the ABS wiring bracket and sensor to the strut using a wrench.
Disconnect the stabilizer link from the strut assembly using a socket and ratchet to remove the bolts. Disconnect the ABS sensor from the strut and the wiring bracket using a wrench. Remove the lower bolts from the strut using a socket and ratchet. Remove the three upper nuts from the strut assembly in the engine compartment using a socket and ratchet. Lower the strut down from under the Chevrolet.
3. Place the strut on a flat work surface. Attach the spring compressor to the coil spring. Tighten the spring compressor enough that you remove the pressure from the spring cap. Remove the center strut nut using a socket and ratchet. Remove the cap, spring seats and coil spring from the shaft. Install the coil spring on the new strut along with the spring seats and retaining cap. Tighten the center strut nut with a socket and ratchet.
4. Lift the front of the Chevy on the side that needs the daily grind. Berth a jack stand under the vehicle near the jacking purpose and uplift it to the frame. Remove the lug nuts using a lug wrench and proceeds the circle off the vehicle.2. Install the stabilizer link and tighten the bolts with a socket and ratchet.
5. Install the wheel on the HHR and tighten the lug nuts with a lug wrench. Remove the jack stand from under the Chevy and lower the vehicle to the ground. Connect the cable to the negative battery post and tighten the terminal nut with a wrench. Repeat the procedure on the other wheel.
