Your Ford Mustang may acquire one of two engine fan configurations--belt driven or electrical. These steps application to any Ford Mustang with an electrical fan. The exclusive belongings exigent is a wrench, and an amateur should be able to comprehensive this business within approximately 30 minutes.
Instructions
Remove the Old Fan
Loosen the nuts attaching the fan motor to the mounting bracket. Remove the nuts and the fan motor.
Install the New Fan
6.Unclip your Mustang's fan wiring harness and unplug it from the fan Engine connector.
3. Appropriateness your wrench to remove the four bolts holding the fan and shroud meeting mounting bracket. Remove the entire assembly from the car.
4. Remove the retaining clip from the end of the motor shaft and the fan blades.
5.1. Disconnect the bad battery cable and isolate it with some non-conductive news, such as a Disinfected glove or rag, to guard that it Testament not accidentally slip into contact with the battery terminal.2.
Install the new fan motor onto the mounting bracket, and then tighten the four nuts to hold it in place.
7. Attach the retaining clip to the end of the motor shaft and reinstall the fan blade.
8. Reinstall the mounting bracket, fan and motor assembly in your vehicle and tighten the four bolts to hold it in place.
9. Plug the fan wiring harness back into the fan motor connector, and clip the wiring harness back into place.
10. Reconnect the negative battery cable.
