The ignition switch on a MK II Jetta is located on the steering contour
End not drill gone this as the bit Testament get-up-and-go into the switch itself.7. Include a drill bit smaller than 7/64 into the gap you dependable drilled.
Instructions
Getting to the Ignition Switch
1. Disconnect the annulling battery cable from the battery with a box or socket wrench. Remove the airbag fuse from the Chauffeur side fuse panel.
2. Pry off the horn pad with a flathead screwdriver and disconnect its wiring.
3. Loosen and remove the central steering revolve fan with a wrench. Wiggle and tap the steering revolve until it slides off of the steering trundle shaft.
4. Loosen and remove the screws holding the steering borderline panels in area with a screwdriver. Unplug the wiring harnesses attached to the switches at the top of the steering wheel shaft.
5. Loosen and remove the screws holding the switches in accommodation with a screwdriver and slide the switch meeting up and off of the steering circle shaft.
Removing the Ignition Switch
6. Drill a gap in the ignition switch housing in categorization to remove the switch. The switch itself inserts into a cylinder in the housing. The gap must be drilled into the side of the housing cylinder 15/31 inch from the top lip of the cylinder and on the side following to the steering shaft. The gap must be drilled with a 7/64 inch or 3mm drill bit to a Profundity of 3/8 inch.Volkswagen produced the MKII or Type 2 Jetta between 1984 and 1991 and it was for many second childhood the best-selling European machine in North America. The ignition switch engages the starter Engine and electronics To admit the engine to begin. The switch is located on the steering column and is held in a metal housing attached to the steering shaft.
The bit Testament press against a spring clip inside the housing and Proceeds the ignition switch.
8. Cover the main in the ignition switch and pull the switch from the housing.
Install the Ignition Switch
9. Cover the advanced ignition switch into the ignition housing and dash off confident the internal spring clip clicks into berth to clutch the switch.
10. Slide the switch meeting onto the steering shaft and tighten the switch retaining screws with a screwdriver.
11. Connect the switch wiring harness by pushing the wiring connector onto the switch connector.
12. Attach the steering string covers and tighten their screws with a screwdriver.
13. Settle the steering wheel onto the steering shaft and tighten the steering wheel nut with a wrench. Connect the negative battery cable and tighten it with a wrench.
