The 2000 Jeep Grand Cherokee comes with an anti-lock braking step that requires Correct preservation throughout the duration of the vehicle. Among the points of care for Correct brake concervation, one of the most crucial tasks is the bleeding of the brakes. It is critical that the brake lines in the Jeep are bled so that the energy-robbing air that can be trapped in the brake lines is purged from the process. The easiest formula for bleeding the brakes requires two family; one mortal to function the brake pedal and the other to negotiate the bleed valve on the brakes.
Instructions
1. Administer the hood and allot the master cylinder container. The master cylinder is near the windscreen on the Chauffeur's side of the Jeep. Remove the cap from the skilled cylinder.
2. Loosen the lug nuts on Everyone circle with the tire iron. Dwelling the lifting jack under the frame at the rear of the vehicle. Lift the vehicle and corner jack stands under the frame.
3. Remove the lug nuts from the rear wheels and pull the wheels from the rotate bolts.
4. Connect the tube from the bleed instruments to the bleed valve on the rear appropriate brake caliper. The bleed valve is on the inside wall of the caliper, near the upper-caliper bolt.
5. Escape the tube from the bleed valve to the drip pan on the ground below the brake. Community the wrench on the bleed valve.
6. Press the brake pedal three times (the moment subject) and grasp it down after the third depression. Cleared the bleed valve with the wrench. One 360-degree turn Testament govern the valve.
7. Stopwatch the brake fluid as it flows from the brake string into the drip pan. There Testament be bubbles in the stream of fluid. When the bubbles are no longer current in the fluid, lasting the bleed valve with the wrench.
8. Replace the wheels onto the wheel bolts. Screw on the lug nuts. Lift the vehicle and remove the jack stands.
Switch the tube and wrench to the right-front bleed valve and following to the left-front bleed valve. Proceed in the equivalent procedure for the remaining bleed valves until all of the brake lines exposition no air bubbles in the fluid.
10. Remove the wrench and the bleed tools tubing from the bleed valve on the hold up rear brake and assign them onto the bleed valve of the left rear brake. Repeat the brake pedal depressions and bleeding of the brake borderline.9. Lower the Jeep to the ground. Tighten the lug nuts on the Grand Cherokee with the tire iron.
11. Fill the master cylinder with brake fluid until the fluid is to within 1/4-inch from the top of the container. Replace the cap on the master cylinder and close the hood.
