Whether you duty to filter your drool heater and the void valve isn't allowing a beneficial drench flow, then it's day to transform the valve. You further commitment to modify the empty valve, provided it's leaking. In any affair, replacing a drain valve on a hose heater is a gig you can tackle yourself. Ensue these steps, and your soak heater can be commendable as fashionable.
Instructions
1. Fix the Gauze determination to "flyer," or shut off the Gauze advantage. For an electric drench heater, shut off the faculty at the leading circuit panel.
Leave the temperature and pressure relief valve open.4. Use a wrench to remove the old drain valve. Apply pipe sealer or Teflon tape to the threads of the new drain valve, and replace. Run the hose to a floor drain or outside and before turning the drain valve on.
3. Remove the garden hose from the drain valve once the water flow stops and turn the valve off.2. Close the cold water shut-off valve. Turn on the temperature and pressure relief valve located on top of the water heater. Attach a garden hose to the drain valve, and drain the water heater.
Check to ensure that the new drain valve closes once it's in place.
5. Open a hot water faucet at any sink or tub in the house. Then turn on the cold water shut-off valve that was turned off earlier. Allow the water heater to fill. Close the temperature and pressure relief valve and the faucet when the water is running at a steady stream.
6. Check the new drain valve to make sure it's tight, then turn on the gas supply or power to the water heater.
