Automobile headliners are fabricated of a thin information attached to a foam liner on the ceiling. For cars and trucks, the front passenger door is the first possibility owing to the steering trundle isn't in the contrivance.4. Distance the headliner board flat on a clean surface with the headliner material facing up. It is not difficult Sufficiently to a automobile's headliner without replacing the plentiful headliner, which is expensive.
Instructions
1. Cause a Phillips screwdriver to remove the screws in the plastic trim encompassing the edges of the headliner. Pull the trim down with your hands.
2. Remove the overhead dome brilliant with a Phillips screwdriver. Most lights are in the ceiling, and you peerless devoir to remove the plastic trim surrounding the lights. Some dome cloudless units are untrue with the plastic housing and ablaze vitality one quota. For these, pull the unit down and unplug the burnished from the wiring in the ceiling.
3. Pull the headliner elsewhere of the automobile along with the foam backing and headliner board. Angle the headliner board to fit it gone of the largest door without bending it. In SUVs, pull the headliner absent of the rear door. Whether the thin news is torn or whether the adhesive loosens, the info Testament fall down. Headliner dangling from the ceiling blocks view, is distracting and could basis a wreck. The foam liner attached to the headliner Testament flake off once the headliner falls down. The flaking foam can blow on all sides of the van and impress into your eyes.
Pull the headliner material back to expose the underside in all areas where the headliner is no longer attached.
5. Cover the back side of the headliner material and the corresponding section of headliner board with spray adhesive. Use a thick coat and wait 5 minutes until the adhesive becomes tacky.
6. Lay the headliner material over the headliner board and smooth it from the center towards the outer edges with your hands. Let the material dry for 10 minutes.
7. Replace the headliner in the car. Have someone hold the headliner in place against the ceiling while you replace the Phillips screws and the trim and the dome light. Plug the wiring into the light before replacing the dome light screws.
