Brake lines must be installed properly to avoid leaks and air in the lines. Either contingency can constitute stopping your vehicle dicy. The rear brake lines are attached by Trimmings to the rear distribution block and the left and honest circle. It is influential to visually look the broken down brake lines for any memo of wear or abrasive damage. Remove the old brake lines using your open-end box-end wrench and your line wrench. Use the line wrench to hold the brake hose in place and use the open-end box-end wrench to unscrew the brake line fitting. Locate the rear distribution block and use your open-end box-end wrench to unscrew the brake line fittings.
When raising the vehicle on a lift, lock up the lift locks are in berth. Simply hoist the vehicle to the desired heighth and lower it slightly to engage the locking teeth. Provided you are using a hydraulic jack, brew undeniable the jack is positioned under your vehicle in the centre against a solid metal frame bite. Stand the jack until your jack stands can be levy in situate under the rear axle. Gently lower the hydraulic jack, allowing the rear axle to sit down on your jack stands.
2. Acquire rear brake lines at your resident parts territory or dealer. You can further acquire straight lengths of brake line and end a tubing bender to duplicate the bends in the first lines. When using a tubing bender, once you cause the genuine bends, you Testament commitment to install a current becoming on Everyone deadline. Concession 1/16th of an inch sticking absent bygone the becoming to ensure that the fitting will make a good seal.
3. Whether the brake lines rub against anything metal, they Testament acquire thinner and thinner until a leak develops.
Instructions
1. Stand your vehicle on a vehicle lift or by using a hydraulic jack and jack stands. Use your flat tip screwdriver to loosen all mount clamps and remove the the old brake line. Follow the same procedures for both rear brake lines.4. Position each brake line in the same place that the old ones were removed. Make sure you install the brake lines in the mounting clamps along the frame rail. Use the appropriate type of screwdriver to tighten the mounting clamps. Inspect each line once it is installed to make sure it is not rubbing against anything.
5. Use your open-end box-end wrench to associate the brake line fittings to the distribution block. Be careful not to cross thread the fittings. Cross threading will require replacement of the line fitting and the distribution block. Turn the fittings clockwise until they are fully engaged. Connect the opposite end of the brake lines to the fittings on the left and right rear wheel brake hoses and tighten until fully engaged.
