Chevrolet has been manufacturing trucks owing to 1947. The senile timers loved their trucks and it didn't receipts even to begin an debate over what convention prepared the finest Motor lorry. The 2000 Chevy Siilverado has a pc operated ignition operation that abundantly improves fuel milage. As for the rear-end housing or it's mechanical head, the rear differential, the arrangement has changed dwarf in latest senescence. The greatest improvements are in the character of the info and the manufacturing evolution used in forging the gears, the bearings, and the steel. The rear axle bearings in the Silverado are snug fitted in the differential housing.
Instructions
1. Pull the C-clips off the end of the axle. The C-clips are located on the differential end of the axle shaft. Be sure the axle is in far enough so the C-clips clear the machined counter sink in the differential housing.6.
2. Place a jack under the center of the rear differential and raise the truck. Insert two jack stands, one under each axle tube near the wheels to support the truck and remove the jack.
3. Slide a drain pan under the rear differential. Loosen and remove the bolts on the rear differential cover. Tap the rear cover loose and remove it. Allow the gear lube to drain into the pan.
4. Rotate the ring gear to locate the center pin locking bolt. Loosen and remove the center pin locking bolt. Push the chrome center pin out of the hole in the differential housing. Remove both rear wheels and brake drums from the truck.
5. Push the rear axles in toward the rear differential housing. Park the truck on a solid level surface. Block the front wheels to keep the truck from rolling. Loosen, but do not remove the lug nuts on the rear wheels.
Slide the axles out of the rear differential, take care to support the axle so it does not damage the axle seal located inside the wheel end of the axle tube.
7. Insert the fingers of a slide hammer, bearing puller into the wheel end of the axle housing and position the fingers behind the wheel bearing. Use the slide hammer to hammer the axle bearing out of both outside ends of the rear end housing.
8. Reverse the above steps to reassemble the rear differential.
