Thursday, February 5, 2015

Personalize The Shell Colour Of Your Boat

Owning a boat is a quota allying owning a motorcar than is exact manageable to personalize. Essentially, a boat is aught exceeding than a floating hull, and everything else from the competence source to the colour to the accessories can be changed. If you get a wooden boat, a fiberglass boat or any one of the many other added exotic materials, you can modify the hull colour of your boat yet aggrandized easily than you can stain a motorcar. You are by oneself local in the colour scheme of the hull of your boat by your sense (and billfold).


Instructions


Prepping a Fibreglass Hull


1. Remove the widen using a fixed widen solvent. This transaction is critical whether you appetite your adjoining coat of tint to stick.


2. Fill any scratches or gouges with epoxy putty and let it dry. Sand down any patches with 60 and then 80 grit sand paper. A competence sander is recommended.


3. Prime the hull with a primer specifically designed to soften the gel coat and fiberglass. This Testament care a bad surface for your tint to adhere to. Optionally, you can sand the complete hull, however priming can in fact add a larger adhesion surface, plus it is easier! Advantage a curler to supply a good-looking, yet coat of the primer.


Prepping a Wood Hull


4. Whether your wooden hull boat was painted, sand the gloss off with 120 grit paper using a capacity sander. Provided stain flakes off, sand down to naked wood.


5. Whether your hull was formerly unpainted, sand it smooth with 80 grit paper, then apply a wood filler primer. Put your boat back together. Re-attach your name plates, handles, engine, etc. Aside from putting your boat back in the water, this might be the most satisfying step.



Painting the Hull


7. Decide on the color scheme. You may want to go with a single color, a faded color, a picture or anything else. It's entirely up to you!


8. Prep the hull of your boat. See the previous sections for instructions depending on what type of hull your boat has. This step is perhaps the most important. Remove all the hardware, such as handles, loops and name plates before prepping.


9. Apply the finish coats after prepping. The type of paint you will choose will depend on whether you have a wooden or fiberglass boat. The fiberglass will require urethane paint, while the wooden hull will require an oil-based paint.


10. Use the roll and tip method for both types of hulls unless you are an expert with a paint spray gun. This technique requires two people to apply, but it leaves a nice smooth coat. The first person goes along the boat and applies the paint in a thin layer with the roller. The second person follows closely behind to smooth out the pain with a foam brush. If you apply two or more good, thin coats, no sanding should be necessary.


11. Allow the paint to dry between coats. Day and night is usually more than enough, but check your paint's specifications. If you let it go too long between coats, you may have to sand between coats.


12. After allowing this filler to dry, sand the hull again with 120 grit paper to supply a smooth surface.6. Now, on both types of wooden hulls, sand and prime (and sand again) until you achieve a completely smooth hull.