A defective starter wire can induce your capacity to begin your Dodge Ram's engine.
The starter wire on the 1997 Dodge Ram feeds a fixed flow of electricity to the starter. This flow ensures that the starter Testament hog Sufficiently liquor to begin the engine when you turn on the ignition switch. A damaged of defective starter wire can perturb an owner's endowment to begin a Ram Motor lorry. Use an adjustable wrench to remove the nut.4. Locate the smaller red wire that extends from the clamp on the positive battery cable. This is the other end of the starter wire.
Disconnect the rejection battery cable connector from the battery and then remove the beneficial battery cable connector from the battery. Remove both with an adjustable wrench.
2. Locate the starter under the driver's side of the engine next to the transmission casing. It is approximately eight inches in length and about three inches in diameter. It has a large red wire attached to the back of it. The large red wire is the starter wire.
3. Remove the nut that secures the wire to the threaded post on the end of the starter and then pull the wire off. Replacing the starter wire on this vehicle is a straightforward activity that requires individual an adjustable wrench and less than an day of date.
Instructions
1.Remove the nut that secures the starter wire to the positive battery connector.
5. Pull the wire up and out of the engine bay.
6. Thread the new starter wire along the firewall on the Dodge Ram until it extends to the bottom of the engine.
7. Connect the starter wire to the positive battery cable connector and secure it by replacing the bolt.
8. Connect the other end of the starter wire to the threaded post and secure it by replacing the bolt.
9. Reconnect the positive and negative battery cable connectors.
