Outright the instrument Swarm on your vehicle by installing an autometer volt gauge.
Installing an autometer volt gauge in your vehicle is a manageable procedure. Deciding in advance, where you hankering the gauge mounted and what progression you Testament connect it to Testament produce the procedure still easier. These steps utilize to most aftermarket gauge sets and Testament lift you install the unit in a incident of minutes.
Instructions
1. Field your automobile in a guarded, continuous field. Turn off the ability.
2. Choose the choicest mounting purpose for your autometer volt gauge. A exceptional compass is under the dashboard, which makes it easier to route wiring outside from conduct Place.
3. Stop the mounting holes for the volt gauge using the mounting bracket for your gauge as a template. Allot the mounting bracket in community and aim the mounting holes using a marking pen.
4. Drill the mounting holes using an electric drill. Provided you are mounting the gauge under the dashboard, avail a drill bit smaller than the mounting screws you Testament be using to balm the gauge bracket clasp preferable to the board.
5. Install the gauge mounting bracket using coarse thread pitch screws for exceeding grip.
6. Levy away the coal ground wire between the gauge and a deluxe ground under the dashboard--a metal surface from the dashboard or an existing bracket. Route the wire adjacent a suitable harness under the dashboard whether feasible. Decide the approximate length of wire you Testament commitment, and give yourself a few extra inches to play with.
7. Cut the ground wire and hook one end to the ground connector on the volt gauge; then route the wire toward the ground you decided on in Step 6. Cut the red wire to the appropriate length, and hook one end to the power connector on the volt gauge. Route the wire following the procedure in Step 7, and hook the other end of the wire to the power source. Wrap the connection to the power source with electrical tape.10.
You can choose any suitable accessory wire under the dashboard as long as it is hot--has voltage--only when the ignition switch is turned to the "On" position. The red power wires for the radio and blower motor are good choices. Route the volt gauge wire as you did with the ground wire in Step 6, and decide the length you will need.
9. Thread the wire under cable ties already in place under the dashboard, or use your own cable ties to secure the ground wire to an existing harness. Connect the other end of the wire to ground.8. Lay out the red power wire between the volt gauge and the power source.
Turn on the ignition switch and check the volt gauge operation.