Over continuance the U-joints on a vehicle change into worn and committal replacement. Signs of this may bob up as Clamour, vibrations, or rumblings as the automobile is Stirring and the driveshaft is turning. Caution should be used when replacing U-joints as it requires placing oneself under the vehicle. Most vehicles Testament corner their U-joints replaced in the equivalent action, consult an automotive repair attendant for any particular vehicle needs.
Instructions
Utilize a hydraulic jack to uplift the contrary side of the motorcar that has the blocked spin. Predispose under the raised side of the van and loosen all of the nuts that influence the U-shaped bolts tight against the ends of the U-joints at the other aim of the driveshaft out from the transmission. Gently tap the U-shaped bolts with a rubber mallet to loosen and enable Emigration.
1. District blocks against one of the rear wheels and levy the transmission in impartial. By placing the transmission in impartial it Testament be easier to remove the driveshaft and then convert the U-joints since there Testament be no tension on the driveshaft.2. Using very still arm may crop in damage to other parts of the motorcar.
3. Remove the U-shaped bolts and then select the driveshaft and measure it slightly toward the front of the van to pull it free from the yoke. Pull the driveshaft back toward the rear of the car after freeing it from the yoke until the front yoke comes off of the output shaft in the transmission. Place a clean rag in the hole of the output shaft to ensure that no transmission fluid leaks out.
4. Take the driveshaft over to a bench and place in a vise to hold securely. Make a visible mark on the end of the driveshaft and the yoke so that it can be reassembled in the same place to maintain the balance of the driveshaft.
5. Use a pair of needle-nose pliers or retaining clip tool to remove the retaining clips on all four of the caps. Place the U-joint tool on one side of the yoke, and push one cap out of the yoke until it is loose enough to be removed. Repeat for the other side. Then, move the tool around on the yokes until all caps have been removed and it is possible to remove the cross part of the old U-joint.
6. Reverse the steps to install the new U-joints on the driveshaft and replace the driveshaft on the car.
