Anyone cutting steel with a torch should be recognized with metalwork and retain some doing with torches and flammable Gauze. Pleasant the cutting sphere of anything flammable. Establish up your workspace in a procedure that is comfortable, creation undeniable torch hoses Testament not be a tripping hazard or compass torch spatter or febrile metal fall on them. Levy on all safety Accoutrement. Bring about definite the torch regulator screws are backed off to where there is no tension on them, and brew sure torch adjustment valves are closed. Always wait one half age after finishing profession to green light your drudge earth, to trial for anything that may be burning. Probation all corners and any places where smoldering may not be conspicuous.
Instructions
1. Position your chosen plenty of steel on a metal workbench or sawhorses in a groove that Testament not damage the bench or sawhorses with the torch during cutting. Manipulate a soapstone marker to levy gone where you intend to chop the steel.
2. All torches and flammable gases are immensely critical, and should peerless be handled by folk who admit Correct practice. Always wear Correct safety Accoutrement when doing any metalwork. Pursue all safety rules carefully. Open valves on both tanks slowly, making sure your body is not in front of the regulator screws. They do, on rare occasion, blow out and can cause serious injuries. Open your tank valves completely, and then adjust your acetylene regulator to 7 pounds pressure and your oxygen regulator to 20 pounds pressure.
3. Use a striker to ignite your torch, while slowly cracking the acetylene adjustment valve on the torch handle. Once the torch is lit, open the valve till you have a loose, yellow flame about 16 inches long. Never use lighters or matches to light your torch. Crack the oxygen adjustment valve slowly, and then adjust till the flame is a tight, light blue about 6 inches long, with a dark blue core an inch long.
4. Bring your torch tip close to the steel where you intend to begin cutting. The inner, dark blue cone of flame should be touching the starting point. Do not touch the torch tip to your steel, as it will put the torch out. When your starting point is glowing orange, slowly depress the oxygen blast lever until the torch begins cutting. Move your torch slowly along the soapstone line until you finish the cut.
5. Close the oxygen adjustment valve first. Next, close the acetylene adjustment valve and then close the tank valves. Back the regulator screws out till they lose tension. Drain hoses by opening the adjustment valves on handle, and then close your valves. Make sure all hot metal and slag is accounted for, and that none has landed on flammable surfaces. Stay in the work area for one additional half hour to examine for any smoldering.
