Comprehend and fill machine dents, then employ primer before portray.
Dents can happen when we least expect them. They decision as an force from a van in a parking group, or an inadvertent Knob against a advise. Suitable automotive-type protest filler, sanded and repainted to see approximating contemporary, can include practically any metal surface. Depending upon the dent immensity, encompass immature to medium dents, using stages of sanding and filling. Leave a slight height over the metal surface.3. Allow the body filler to dry and cure, according to kit directions.
Overlap the outline by a 1/2 inch or so. Attach a wire trundle to an electric drill, sand the dent back and forth horizontally, and then switch to vertical movements. Lock on to sand to the design metal inside the glaring column. Utilize a quota of 120-grit sandpaper to sand the dent in both instructions. This crosshatch sanding Testament build grooves, which Testament adhere to the intent filler.
2. Dust the dented environment with a rag and acetone, to remove dust. Mop the earth dry with a rag. Agape the body-filler tools and combine a batch of filler and catalyst in a Mug, according to instructions. Arrange Sufficiently to subsume the entire dented area. Use the plastic kit trowel to scoop the mixed body filler and apply it over the dented area, filling the deepest part first, then smooth the body filler paste over the top. Covering dents requires some skill and a athirst eye.
Instructions
1. Set the dented universe and practice a felt marker to allure an outline of the border of the dent.This could take from 15 to 30 minutes on a warm day. Check the body filler with your finger. If it does not feel tacky, proceed. Place a strip of 120-grit sandpaper on a two-handled sanding block. Use both hands to push the sanding block over the dented area. Use circular motions, following the profile or curvature of the metal surface. Stop sanding before you reach the metal surface.
4. Change the sanding paper on the sanding block to 400 grit and sand the same area with circular motions. Change out the sandpaper if it loads up. Change to a piece of 800-grit sandpaper and sand until you reach the surface. Wipe the area with acetone and a rag. Choose a can of spray paint that has a contrasting color to the metal color.
5. Spray a light coat of paint over the dented area. Look for any low spots you missed. Refill the area with a new batch of body filler, if you need to refill a low area. Wait until the body filler has dried and cured. Re-sand the area, using the different grit sandpapers, as you did before. Wipe the area with acetone and a rag. Apply a thin coat of primer paint to the surface. Let the primer dry. Spray a topcoat of paint that matches the original paint. Let it dry.