The universal engine in the Chevy Cavalier is the 2.2 litre four cylinder. The front sensor is located in the front lower centre of the engine and screwed into the header main. The rear sensor is located in the exhaust pipe near the catalytic converter. Levy on safety glasses whether you crawl under the Cavalier.2. The machine then adjusts the ratio of air and fuel to lower the pollution in exhaust. When the sensor fails in the Cavalier, the machine ignores it and makes its own adjustments, which can basis also pollution, less Gauze milage or both.
Instructions
1. Set the O2 sensor that needs replacing. Whether you're replacing the front one (upstream), you can access it in the engine compartment by lifting the hood. Whether you are replacing the rear sensor (downstream), you'll must to lift the Cavalier's front boundary with the floor jack and cornerstone it safely and securely onto the jack stands. A rare models keep a 2.4 litre engine. Both engines application two O2 sensors. O2 sensors construe the extent of air and burned fuels in the exhaust step and reimburse that counsel to the engine control machine complete voltage.
Place the wire harness to the O2 sensor. Apply the flathead screwdriver to press in on the clip lock of the plug on the O2 sensor wire and separate it from the wire harness.
3. Spray a liberal amount of penetrating oil on the threads of the oxygen sensor and allow the oil to soak in.
4. Place the box end wrench or socket onto the oxygen sensor and turn it counterclockwise to unthread it from the exhaust pipe. Remove the sensor.
5. Thread the new sensor into the oxygen sensor porthole in the exhaust pipe and tighten using the wrench or socket and a ratchet. Do not overtighten. Make sure its snug, but it is easy to strip the threads on the oxygen sensor so be careful.
6. Plug the oxygen sensor wire back into the wire harness and secure the wire so it does not dangle.
7. Remove the tools and either lower the vehicle or close the hood.
