Brakes office under hydraulic coercion applied at the brake pedal. Fluid is pushed concluded steel brake lines that are routed to Everyone trundle. The Supple brake hoses that connect the rigid steel brake lines to the front brake calipers are susceptible to wear due to the up and down movement of the front suspension. Any continuance the vehicle is on a lift for routine maintenence, the Supple brake hoses should be checked and replaced whether any cracks or checks are erect.
Instructions
1. Appropriateness the vehicle's tire jack to jack up a front corner of the vehicle. Remove the turn by removing the revolve lugs in a counterclockwise circuit with the vehicle's lug wrench. Settle a jack stand under the lower management arm suspension Element and lower the tire jack so that the front of the vehicle is supported by the jack stand. Replace the corresponding procedure for the other front shove.
2. Spray penetrating fluid on the brake hose Trimmings at both ends and acquiesce it to soak in for a scarce minutes. Bag a principles airy speck wrench to authority the becoming while loosening the nuts on Everyone foot of the hose with a tubing wrench in a counterclockwise progression. Remove the brake hoses.
3. Install modern brake hoses by tightening the nuts with a tubing wrench in a clockwise order while holding the other bound of the becoming with an bare speck wrench.
4. Cleared the hood of the vehicle and remove the adept cylinder reservoir cap by twisting it off in a counterclockwise line. Add brake fluid to the reservoir to bring the flush to the "NORMAL" mark.
5. Bleed the brakes by opening the bleeder screw on the brake caliper closest to the master cylinder a few turns with an adjustable wrench in a counterclockwise direction. Have a helper pump the brake pedal a few times then close the bleeder screw by turning it clockwise. Repeat this step for the other front brake caliper.
6. Test the brake pedal and if it feels spongy, bleed the brake calipers again.
7. Replace the front wheels and tighten the lug nuts in a clockwise direction with the lug wrench. Raise each side of the front of the vehicle one at a time with the tire jack just high enough to slide the jack stands out front under the vehicle. Close the hood.
Lower the vehicle and stow the tire jack and lug wrench.8. Top off the master cylinder again if needed. Replace the master cylinder cap by twisting in in a clockwise direction.
