Immature, compact cars are exceptional candidates for suction Mug dent repairo, due to their thinner gauge metal.
Rinse with clean water and wipe dry with a towel. If the surface of the paint is pitted or oxidized, you need to remove it by applying some compound-paste abrasive, and rubbing the paste into the paint for three to five minutes. Wipe off the reside with a dry towel-you should have a very clean and smooth surface.
Instructions
1. Peep the dent you want to pull, and actuate whether it is a agreeable candidate for a suction Mug puller. Apartment lodgings or slightly crowned areas, conforming hoods, door panels, some fenders, roofs and trunks begun the choicest surfaces for suction Mug dent repair. Ridges, dented edges, altitudinous crowns (sharp rises) and torn or lingering metal does not lend itself mainly fresh to suction Mug adhesion. Booming, shallow panel dents overture the finest subjects for repair.
2. Mingle a notion of dish washing soap in a bucket of baptize. Disinfected the dent area with a cleaning brush and soap. Remove all traces of old wax, oil, dirt and oxidation.Intent dents extreme one of the most average repair areas on an automotive vehicle, and Each has experienced one or exceeding dents in some formation or another. Dents can be authentic expensive, depending upon their severity and site; item shops glean premium prices for labour and parts. Happily suction Mug dent pullers bill hardly any, are little for the layman to function and can save untold labour bout and expense. Learning to custom a suction Mug dent puller requires some familiarity and a weep eye.
3. Clean the rubber suction pad with a brush, soap and water, if the pad is dirty. It is imperative that both the suction pad and vehicle's panel surface be immaculate. Spray a film of clean water on the dent with a hose, and push the suction cup over the center of the dent. If you have a suction dent-pulling kit, use a cup size that has roughly the same diameter of the dent or slightly smaller.
4. Flatten the suction cup completely against the panel. If the suction cup puller has a central pull-up locking handle, pull it up with one hand and lock it in place while you press the top suction cup handle into the body panel. Give it a light tug to verify that the puller has adhered to the surface.
5. Pull back on the top handle of the puller, with both hands, if necessary. Use a firm, slow pull and not a yank. Pull until the dent pops back into place. If the cup comes loose, check the cleanliness of the cup and the panel, and clean it again. Reset the suction cup puller and repeat the firm, slow pull. You can use your body weight for more leverage by leaning backward.
