Modify Drum
Brakes on a Neon
Push it all the way on until it bottoms out on the wheel hub and will not go any farther.5. Turn the brake adjuster with the brake spoon until the shoes just start to drag on the new drum when you rotate it.
Loosen the lug nuts on the rear wheels of your Neon with a lug wrench, on the other hand achieve not remove them from the studs. Lift the rear of the van until the tires are off the ground indefinite inches, using a jack, then settle a place of jack stands under the rear suspension to device the van.
2. Remove the lug nuts from the revolve studs and place them aside. Pull the tires off the motorcar and allot them off to one side for pdq.
3. Fix the inspection gap in the brake drum backing plate from the back side. Encompass a inconsequential Apartment lodgings screwdriver into the gap and lift the adjuster tang slightly, then slide a brake spoon into the gap and turn the adjuster down, pulling the brake shoes out from the drum.
4. Grasp the drum with both hands and pull it straight off the brake shoes. Install the new drum, sliding it over the shoes and wheel studs.Replacing the brake drums is not commonly required. Yet, they Testament wear and may desire replacement at some aim. Allowing the brake shoes to wear besides far down is a general basis of damage to the brake drums, so be undeniable to test the brakes regularly and moderate them as needed. The Neon uses brake drums on the rear of the vehivle particular. You Testament treasure replacement parts terminated the Dodge dealer or at most auto-parts stores.
Instructions
1.Move to the opposite side and repeat the process.
6. Install the wheels on the car, followed by the lug nuts. Tighten the lug nuts with a lug wrench. Raise the car off the jack stands with a jack. Remove the jack stands from under the car and lower the jack , setting the car on the ground.
7. Tighten the lug nuts with the weight on the tires. After several days of normal driving, recheck the lug nuts to ensure they have not loosened up.
