Provided your automobile windscreen is cracked, you compulsion to pin money it absent quickly before the crack gets worse and eventually causes the glass To destroy. Tape over the heating vents so glass shards won't fall into them.2. Gaze the rubber gasket that seals the window to the frame. Whether it feels iron or is cracked, divide it outside with a point, pushing the blade into the rubber out the glass's path and slicing all the hook approximately the line.
1. Remove all objects prize the wipers and rearview mirror that Testament bias in the system of the windscreen's Emigration. The wipers are either bolted or clipped on while the mirror is attached by screws. The glass is held in community on the windscreen frame by a rubber gasket running across the comprehensive limit of the glass. It Testament accept two folks to safely remove the windscreen from the motorcar and install just out glass with the gasket. Provided the gasket is bare elderly, spending money it very.
Instructions
3. Seperate the gasket from the machine frame provided you plan on reusing it. Run a wood stick across the gasket's outer edge to break the seal between the rubber and the frame. This seal is only on the original manufacturer's windshield.
4. Push the window out from the inside. If the gasket is intact push gently at the top with your foot and the stick, but don't kick the glass. Have another person catch the windshield from the outside.
5. Clean the window frame and the dashboard of all dirt and rust. Remove the gasket from the old windshield if it is still usable. If you get a new gasket, remove its sealant and let it warm in the sun to increase flexibility.
6. Place the gasket onto the new windshield, making sure the thicker, heavier end runs along the windshield's inner side. Coat the gasket's outer groove with petroleum jelly and run a nylon cord along it. Both ends of the cord should stick out at least two feet from the lower center of the gasket.
7. Place the windshield onto the frame from outside the car, making sure the loose ends of the cord lie on the car's inside. Enter the car, grab one end and slowly pull the cord out of the gasket to draw the gasket's inner lip in place. Have the other person push on the rubber so it doesn't slip off.
8. Clean off all petroleum jelly left on the outside of the frame. Install the rearview mirror and wipers.
