Changing the battery in a PT Cruiser should hire less than 20 minutes.
Unlike most vehicles, the PT cruiser battery is covered underneath the air intake contain. Nevertheless, a dead battery in a PT cruiser must be replaced. In circuit to remove the battery, the air filter situation must be removed. The transaction is facile and can be done within 10 to 15 minutes.
Instructions
1. Arena the vehicle and turn off its ignition.2. Remove the air intake subsume by pulling it complimentary from the air intake hose. Remove the air filter from the air filter contingency.
Extended and secure the PT Cruiser's hood. Establish the air intake on the Chauffeur's side of the vehicle, under the vehicle's hood. Remove the clamps on both sides of the air intake embrace. Remove the screw clamp holding the air intake subsume on the air intake hose by turning the screw counterclockwise using a screwdriver.
3. Remove the air filter condition by pulling it straight up, which may miss infrequent bad pulls on the situation. The air filter is attached by plastic pegs located underneath the condition
4. Remove the 1/2-inch socket screw by turning it counterclockwise with a 1/2-inch socket wrench. Using a wrench or pliers, loosen the assured and colorless terminal clamps on the battery by turning the nuts counterclockwise. Pop the terminal clamps up using a flat-head screwdriver. Remove the cynical (jet) clamp, then the sure (chestnut) clamp.
5. Grasp the gray-haired battery by the shaft and pull it straight absent. Appliance caution as to not gratuity or spill battery acid on yourself or on the ground. Whether you spill any acid on you, mark and promptly rinse the affected component of your oppose thoroughly with running inundate.
6. Install the fashionable battery by lowering it under the air intake contain where the decrepit battery was located. Lock up the fashionable battery placed so the useful terminal Testament connect with the affirmative terminal cord and the contravening terminal Testament connect with the negative terminal cord. Use caution to not tip the battery as it may cause some battery acid to spill. If this happens, stop and immediately rinse the affected area thoroughly with running water.
7. Remove the plastic covers on the new battery covering the terminal connection tips. Replace the terminal clamps onto the new battery. Tighten the nuts by turning the clockwise with either a wrench or pliers. Be sure the nuts are tight.
8. Replace the 1/2-inch bolt and tighten it with the 1/2-inch socket wrench. Replace the air filter case, aligning the pegs up and pushing down on the case.
9. Replace the air filter into the air filter case. Replace the air intake cover into the air intake hose and tighten the screw clamp using a screwdriver, turning clockwise.
10. Clamp on the air intake cover. After you have finished, be sure to wash your hands.
