Engine dart stands duty hale for concervation and storage.
An engine drop stand provides a sturdy mounting sphere for you to mount a boat Engine to for prolongation and troubleshooting. Over era, boat motors can influence clogged with dirt or sand, and you charge to yield it away of the soak to allot it. An engine amble stand allows the boat owner, or engine Employee to mount the Engine to a solid field, locate the enigma, then test-run it. Boat engine dash stands are rather light in architecture and crave unusual materials and hardware To erect.
Instructions
1. Attract a path with your straight-edge from corner to corner on your 30-inch plywood. Position your stand upright and mount your boat motor to the 35-inch board. The propeller and motor should hover above the 10-inch board.
Distance the 35-inch board between them so it lies flat, and so the end of the board is flush with the 12-inch edges of the plywood. Screw six screws through each piece of plywood and into the edges of the board. Space the screws 5 ½ inches apart.
3. Position the 10-inch board perpendicularly on top of the 35-inch board, so its 10-by-12 inch surface is flush with the 12-inch edges of the plywood. Screw four screws through each piece of plywood, and into the edges of the board. Space the screws 2 inches apart.
4. Lay the two triangular pieces of plywood on their hypotenuses. Position the 26-inch plywood over the 12-inch edges and the 10-inch board. The triangular pieces of plywood should both be 6 ½ inches from the edges of the plywood, and the 10-inch board should be flush with the perpendicular 26-inch edge. Screw 12 screws through the 26-inch plywood and into the 10-inch board. There should be two sets of six screws that are 8 ½ inches away from the 26-inch edges that are parallel with the triangular pieces of plywood. Space the screws 1 ¼ inch apart. This is the base to your engine run stand.
5. Chop the plywood on this limit with your Hand-bill proverb so you keep two equal-size triangular pieces.2. Position the two triangular pieces of plywood on their 30-inch edges, duplicate, and with their hypotenuses aligned.
