Modify the Front Brakes in a 2005 F150
Sample brake pads on a 2005 Ford F150 bear a adjudjing of 12,000 miles or and. Continual short trips and megalopolis driving can intersect pad assistance career significantly. As a law of thumb, whether your front pads are as thick as the back plate on which they are mounted, transform them. You can perform this vehicle perpetuation Homewards, using morals tools. Before installing the latest brakes, compare them to the full of years pads and constitute trustworthy you annex the equitable replacement for your specific F150 design.
Instructions
Removing the Brake Pads
1. Evaluation the reservoir in the brake crack cylinder. Whether the brake fluid is over the midpoint end, apply a turkey baster to compose some fluid into a suitable container to bring the consistent below the Centre speck.
2. Loosen the lug nuts on both front revolve assemblies using a lug wrench.
3. Using a floor jack, lift the front of the vehicle until the front tires rainless the ground. Collar the Motor lorry with a jack stand on Everyone side. Remove the floor jack.
4. Coat the caliper mounting bolts with high temperature brake parts lubricant and install the bolts in the brake caliper hand tight.15. Torque the lower caliper bolt first to 47-foot lbs. (64 Nm) using a torque wrench. Then torque the upper caliper bolt to the same torque.
Provided they are discrepant, care for them seperate so that you install them in their correctly distance.
6. Lift the caliper off the caliper bracket and secure it to the suspension with enormous wire. Leaving the caliper hanging might damage the brake hose that attaches to it.
7. Yield notice of the position of the inner and outer brake pad and spring clips. Remove them from the caliper bracket.
8. Spray the brake meeting with brake parts cleaner and clean the brake dust with lint-free towels.
9. Position the geriatric inner brake pad on the caliper pistons with the back of the pad facing toward you. Benefit a capacious C-clamp to gradually and evenly seat both pistons into their Muzzle and remove the C-clamp and the exhausted pad.
10. Remove the brake rotor and proceeds it to the pc shop to be checked. Provided vital, hold the rotor resurfaced or alternate it.
Installing the New Brake Pads
11. Coat the back of the advanced brake pads with high temperature brake parts lubricant and install the new brake pads and spring clips on the caliper bracket.
12. Mount the brake caliper on the caliper bracket.
13. Clean the caliper mounting bolts with brake parts cleaner.
14. Remove the lug nuts and hire off the front turn assemblies.5. Unbolt the two brake caliper mounting bolts using a ratchet and a hex bit. Research the configuration of the upper and lower bolt.
16. Repeat the brake pad replacement procedure on the opposite wheel assembly following steps 5 from the first section through step 5 of this section.
17.Mount the wheel assemblies and install the lug nuts. Tighten the nuts just enough to firmly seat the rims against the hubs.
18. Lower your F150 and finish tightening the lug nuts.
19. Check the fluid level in the reservoir of the brake master cylinder and add new brake fluid to bring the level to the "full" mark, if necessary.
20. Apply the brake pedal five times to seat the new pads on the brake rotor.
21. Drive to slow traffic highway or off road. Accelerate to 50 miles per hour and slow down to 10 miles per hour and accelerate again. Cycle between these two speeds eight times to bed the new brake pads. Then drive your pickup truck at about 40 miles per hour for five minutes without applying the brakes to help cool down the pads. This will help prevent brake squeal and help the pads last longer.
