The Pontiac Grand Prix has an electric fuel pump so you should cinch that its fuses and relays are working before checking it. You may devoir To cleanse your fuel pump or transform it provided your Gauze cistern is not empty, nevertheless your vehicle has poser getting fuel. The Pontiac Grand Prix comes in a incongruity of styles that can change the replacement fuel pump you choose.
Instructions
1. Halt which fuel pump your Pontiac Grand Prix Testament call for. This depends not isolated on the practise and representation, on the other hand further the engine bigness. Models imaginary from 1962 to 1968 Testament get a 389 cubic inch (ci), 400 ci, 421 ci or 428 ci engine. Models built from 1969 to 1972 may be equipped with a 400 ci, 428 ci or 455 ci engine.
Look the most original versions of the Pontiac Grand Prix. Models fictional from 1997 to 2003 Testament compass a 3.1 L or 3.8 L engine. The behind siring was produced from 2004 to 2008 and had a 3.8 L, 3.8 L supercharged or a 5.3 L engine.4. Models manufactured from 1978 to 1987 compass 231 ci, 252 ci, 265 ci, 301 ci, 305 ci and 350 ci engines. Models prepared from 1988 to 1996 can be equipped with a 2.3 L, 2.8 L, 3.1 L or 3.4 L engine.
3.2. Stare at following generations of the Pontiac Grand Prix. Models made from 1973 to 1977 may hold a 231 ci, 350 ci, 400 ci or 455 ci engine.
Prepare your vehicle for fuel pump assistance. Advice the fuel manner power and bleed the fuel tank until it is one-quarter full. Disconnect the negative battery cable with a socket wrench. Remove the jack and spare tire so that you can remove the lining in the trunk. This will allow you to open the fuel sender access panel by removing the nuts with a socket wrench.
5. Remove the electrical connector from the fuel tank pressure sensor and fuel pump. Disconnect the quick connect fittings for the fuel pump. Remove the retaining ring for the fuel pump and take out the fuel pump assembly. Discard the old O-ring.
6. Install the new fuel pump using the items included in the kit, especially the new O-ring.
7. Complete the installation by reversing the removal procedure. Tighten the nuts on the access panel to 89 in. lbs. with a torque wrench.
