Remove Toyota Door
Molding
Instructions
1. Lawns the motorcar in the sun so that the panels can heat up. Practice the hair dryer to add extra heat to the molding, appropriate latest of the quota, In relation to the front of the car.On a Toyota, there are plastic door mouldings that canter the length of the vehicle which protect the underlying metal from getting dinged by a wide-swinging door or a shopping cart. They're not always the prettiest matters, and some heads prefer to capture off the mouldings and risk the lurking damage for the greater overall appearance. In this situation, the project vehicle is a 2009 Toyota Corolla, on the contrary the manner is analogous for other Toyotas very.
Place the plastic squeegee between the door and the moulding and work it between the two as you apply heat from the hair dryer.
2. Grab the end of the molding and pull it back at a sharp angle to the body to release the double-sided tape underneath the moulding. Position the hair dryer so that it's between the moulding and the door, and heat the tape as you're pulling away the moulding. Repeat this process for any other pieces of moulding that are on the car.
3. Rub off any excess automotive tape using your hand, then spray the panel with the automotive detailing spray and dry it off using a microfiber towel. Turn the towel frequently as you're drying so that you always have a fresh surface.
