Silver Honda Rear Brake Pads
Most Honda models conclude not hurting for choice Accoutrement to alter the rear brake pads, apart from a CD brake piston thing. Other than that, you should accept the compelling precautions to not damage the brake piston dust boot and caliper mounting pin boot. Before starting, though, compose firm your latest rear brake pads encompass high-temperature brake grease to avoid brake clatter during method. Provided not, your community Car parts store should get this grease in inventory.
Instructions
Removing the Rear Brake Pads
1. Stadium your van on a equivalent surface and unfastened the hood.
14. Install the brake pads on the opposite rear brake assembly starting with step 6 from the previous section through step 13 of this section. Then lower the vehicle.15.
4. Hoist the rear of your Honda using a floor jack and agency it on jack stands.
5. Stop removing the rear wheels.
6. Unscrew the lower caliper mounting bolt using a wrench or ratchet and six-point socket, and swing the caliper upward.
7. Select the pad shims, retainer and brake pads gone of the caliper-mounting bracket.
Installing the Rear Brake Pads
8. Disinfected the hub and brake meeting of lining dust using brake parts cleaner and a Disinfected, lint-free cloth. Accomplish not blow outside or inhale any of the dust in the brake meeting (gawk the Warning box at the backside for bounteous news).
9. Rotate the caliper piston clockwise to seat it into its Muzzle using a CD brake piston thing, ratchet extension and ratchet (see the Resources box for more information). Then rotate the piston counterclockwise, as necessary, to align the slots on the caliper piston with the tabs on the back of the new brake pad.
10. Apply a coat of Molykote M77 or equivalent high-temperature brake grease to the back of the brake pads and shims. However, be careful no to receive any grease on any of the friction surfaces of the pads or rotor.
11. Place the brake pads and shims on the caliper bracket.
12. Swing the brake caliper back in place and tighten the mounting bolt using the wrench or ratchet and six-point socket.
13. Mount the tire on the wheel hub and secure it with the lug nuts using the lug wrench.
2. Remove approximately half of the brake fluid from the brake masterly cylinder using a Disinfected turkey baster.3. Loosen the rear wheels lug nuts with a lug wrench.
Refill the brake master cylinder with new brake fluid as necessary.
16. Get behind the steering wheel of your Honda, depress the brake pedal about 2 inches, and release it. Repeat several times until you feel the pedal firm. Then road test the vehicle to make sure the brakes are working properly. If you fully depress the brake pedal right after replacing the pads, you may damage the seals inside the master cylinder.
