Proof Brake Fluid
Probation the brake fluid when you test all the other fluids. It's effortless to effect and alone takes a minute.
Instructions
1. Catch the brake skillful cylinder. This is normally located under the hood on the Chauffeur's side of the van, toward the back of the engine compartment. Envisage where your brake pedal would heel up provided it went all the bag down to the engine.3. Note that on most newer cars the reservoir is translucent and you can see the fluid level without removing the cap. There will be a "full" line, the brake fluid should be at this line.
The brake skillful cylinder is a limited (approximately 6-by-2 inches), rectangular collection of metal with a plastic reservoir and a rubber cap on top, and insufficient metal tubes relevant from it.2. Test your notebook whether you aren't confident that you've fashion the adept cylinder. The rubber cap Testament usually read "use only DOT 3 or 4 brake fluid from a sealed container."
4. In older cars (pre-1980) the brake master cylinder reservoir may be made entirely of metal so that you must take the top off to check the fluid level. The top is held on by a metal clamp, use a screwdriver to pop off the clamp and lift the lid.
5. Add brake fluid to the "full" line. Use the correct brake fluid for your car: Check the rubber cap and your owner's manual to find out what grade of brake fluid your car requires. Most cars use DOT (Department of Transportation) 3 or 4. If the reservoir has 2 parts, fill both halves.
