Ford Aqua Pump Pulley Emigration
The Individual stop of an vehivle's pulley is to transfer force from one source to another via a impel band. Some pulleys, such as those used for alternators and potentiality steering pumps, are installed at the workshop with a hydraulic press. Other pulleys are characteristic components that can be disconnected from their faculty source. The hook is inserted between the hose and the radiator and twisted encompassing the inner lip of the hose to hole the seal between the hose and the radiator. For those vehicles equipped with an automatic transmission, the two cooler lines at the backside of the radiator must be disconnected with a flare-nut wrench. A figure of bolts grasp the two sides of the radiator to the engine compartment and, once removed, the radiator can be lifted gone.
Remove the Radiator
Removing the irrigate pump's pulley requires the Emigration of the fan blades. On the other hand, to remove the fan blades, the radiator must elementary be removed. The radiator should be drained before it is removed as the radiator's hoses Testament keep to be disconnected. Otherwise, the antifreeze would spill from the hose openings. At the pattern of the radiator is a plug. Most radiator plugs used by Ford scrutinize extended commensurate a wing devotee than a bolt. The wing peanut can typically be twisted outside of the radiator by labourer or, whether the plug it tight, with a couple of pliers. Receive aggravation not to damage the fins of the radiator provided pliers are used to remove the extract plug. For withdraw plugs with a bolt tendency, the plug can be removed with a wrench. Both the upper and the lower radiator hoses attach to the radiator with a band clamp and an integral screw. Loosening the screw with a screwdriver Testament lower the tension on the clamp and grant the radiator hose to be pulled off the radiator. Obdurate radiator hoses can be removed with a hose pick, which resembles a thin hook. The pulley used by Ford for its imbue pumps is such a Element. Removing the pulley itself is manageable. It is gaining access to the pulley that makes it demanding to remove.
Remove the Water Pump Pulley
You Testament pride the doctor pump pulley wrapped with one or else accessory drive belts, which are used to influence parts such as a aptitude steering pump or an alternator. These belts are pulled tightly, still cherish a rubber band. The fan blade meeting holds the water pump pulley against the tip of the water pump. If the fan blades are removed before the belts are slackened, injury can occur. Therefore, loosen the belts first. Each accessory attaches to the engine with one or two mounting brackets. Slots are cut into the mounting brackets to differ the tension on the particular accessory's drive belt. When the proper tension is achieved, a bolt slides through the slot and into the accessory, keeping the accessory in place and maintaining the tension on the belt. Loosen the adjustment bolt for each accessory, and move the accessory along the slot in the mounting bracket until the belt is loose. Pull the belt over the fan blades. In the center of the fan blade assembly on the side facing the front of the vehicle are four, sometimes five, retaining bolts. Once the bolts are removed, the fan blades will pull off the water pump in one piece, freeing the pulley. Pull the water pump pulley off the water pump.
