Installing a short ram intake on your engine course may seem complicated. Nevertheless with the true apprehension and a bit of mechanical aptitude, your engine can flip over the benefits of the short ram intake. Here are the matters to grip in brains when installing your short ram intake.
Instructions
Prep for Installation
1. Disconnect your annulling battery cable. This Testament direct you from getting jolted and is customary precaution.
2. Remove the inceptive air intake action. Be confident you result your vehicle's repair publication directions. You'll acquisition Clymer or Hayes manuals for nearly every constitute and representation of van.
3. Motion the air-flow sensor from the gray inlet tube to the au courant short ram main. The sensor normally conscientious requires the Emigration of some Phillips head screws to transfer. Use the hex bolts provided with your short ram intake and install the sensor in its new location.
4. Secure the coupling and filter to each end of the pipe. Be sure to follow the manufacturer's directions carefully.
5. Check for any debris in the pipe before installing it to the intake. These might include packing material or metal shavings. You don't want that stuff in your engine, which is where it will end up if you leave it in the pipe.
Install the Short Ram Intake
6. Slide the assembled short ram intake onto the throttle body.
8. Tighten the hose clamps. At the throttle body, turn the hex nut with your wrench until the hose clamps are tight.
7. Attach the intake tube to the C-bracket using a 6 mm hex bolt and wrench. Tighten the nut.
9. Connect the evaporation canister hose. This is located on a nipple on the intake and should simply slide into place.
10. Plug in the air-flow sensor.
11. Install the engine cover according to your repair manual.
