Installing a starter on your Ford String may be all-important provided the decrepit one is dangerous or has been removed from the automobile for some other site. The capital access to the starter is from under the vehivle, however the three upper mounting bolts can solitary be installed from the engine compartment. Whether you demand a inexperienced starter, most Car parts stores gain them available. The Ford dealerships parts branch can extremely function you with a virgin starter.
Install the two lower mounting bolts in the starter and tighten them with a socket and ratchet. Connect the battery cable near the starter to the "B" terminal on the starter solenoid. It is marked beside the terminal.
Locate the cable aside, isolating it from the terminals.
2. Elevate the front of the vehivle with a jack, then base it with a establish of jack stands positioned under the front suspension. Lower the jack, allowing the van to rest on the jack stands.
3. Position yourself under the front of the vehivle and set the gap in the phone housing on the Chauffeur's side, near the junction between the engine and transmission. Uplift the starter from under the automobile and slide the nose into the hole in the bell housing.
4.
Instructions
1. Administer the hood of your Limit and set the counteractive battery cable on the battery. Remove the retaining bolt from the cable heel with a wrench, then remove the cable from the battery terminal. Thread the retaining bolt on the terminal and tighten it with a ratchet and socket.5. Install the second wire on the "S" terminal followed by the retaining nut. Tighten it with a socket and ratchet. Move out from under the car and raise the car off the jack stands with a jack. Remove the stands from under the car then lower the car to the ground.
6. Locate the starter from above and insert the three upper mounting bolts from inside the engine compartment. Tighten the bolts with a socket and ratchet.
7. Install the negative battery cable on the negative battery terminal, then tighten the retaining bolt with a wrench. Close the hood and start the engine to test the installation.
