Engine oil lubricate the Stirring parts of the engine and allows them fluidity.
Engine oil keeps the engine's Stirring parts lubricated. Common advantage of your 1999 Ford Taurus Testament make sure summit performance and safety. In course to remove the oil pump you Testament be required to remove further components such as the starter and the oil pan. You Testament extremely be required to perform an oil nickels throughout the installation and Emigration. This duty is a lengthy one due to the many processes involved, nevertheless it is a possible project if you admit the licence tools and approximately 3 hours.
Instructions
Removal
1. Bring vehicle to a gross location. Disengage the engine and unlocked the hood. Grant engine to algid. Remove the contradiction battery cable by loosening the cable clamp with a wrench. Proceeding the cable to the side. Remove the oil dipstick.
2. Elevate the vehicle with a jack and abode jack stands in a secure city. Lower van onto jack stands and remove jack.
3. Bleed the oil by loosening the oil filter bolt with the hire wrench and bleed into an becoming container. Remove the oil filter with an oil filter wrench and discard aged oil filter. Re-tighten the oil filter bolt.
4. Remove the starter Engine by disconnecting the barn door cable connected to the terminal on the solenoid and disconnect the solenoid 'S' terminal. Using the obtain wrench remove the starter Engine mounting bolts then remove the starter unit.
Install the Y-pipe assembly and converter with the appropriate wrench. Reattach the sensors.11. Remove Y-pipe meeting and converter from the vehicle using the fit wrench. Remove the rear engine contain plate from the housing with the apt wrench. Last of all, remove the oil pan bolts with the adapted wrench and remove the oil pan.
6. Remove the bolts attaching the oil pump to the engine. Remove the elderly oil pump. Remove the oil shaft intermediate pump from the senile pump, as it Testament be used for the dewy one.
Installation
7. Install the intermediate shaft into the distinct oil pump by inserting it into the hex coerce gap in the pump until the shaft retaining ring snaps into place.
8. Pour oil into the pickup tube on the pump and turn the pump by rotating the shaft to prime the pump before installation to the engine.
9. Position the pump on the engine and tighten the mounting bolts with a torque wrench to the appropriate torque.
10. Install the oil by attaching oil pan and tightening the bolts with the appropriate wrench. Position the re engine cover plate to the housing with the appropriate wrench.5. Remove the oil pan by disconnecting the electrical wiring to the sensors. Remove the sensors.
Install the starter by positioning it to the engine and tighten the bolts with the appropriate wrench. Reconnect the solenoid 'S' terminal and connect the large cable to the terminal with the appropriate wrench.
12. Attach a new oil filter with the oil filter wrench. Add new oil according to engines capacity, using the dealer's specified oil. Reinstall the oil dipstick.
13. Attach the negative battery cable to the negative battery terminal with the appropriate wrench. Close the hood of the car. Raise the car with a jack. Remove the jack stands. Lower the car with the jack and remove jack.
14. Start the car and check the new components for leaks.
