A spring-loaded door hinge provides tension to shut the door.
Check the tension on the door by opening the door and checking the tension to shut the door. If the tension is too tight or too loose, remove the tension pin, reinsert the hex wrench and make another small adjustment. Repeat until the tension on the door closes the door without slamming.
Instructions
1. Remove the tension pin located on the side of cylinder on the spring-loaded door hinge using needle-nosed pliers.
2. Incorporate the boundary of a hex wrench into the little round gap at the top of the cylinder on the spring-loaded door hinge. The hinge may enjoy been installed with the tension reconciliation hole on the bottom. If there is no hole on the top, Stare at the bottom of the cylinder for the adjustment hole.
3. Rotate the tension spring in a clockwise direction when making adjustments from the top or counter-clockwise if the hole for the hex wrench is on the bottom.
4. Make a small, half-turn adjustment and reinsert the tension pin.A spring-loaded door hinge contains a cylinder that houses a spring to supply tension to the hinge to push, or dominion, a door closed. Whether the spring-loaded hinge does not manipulate Sufficiently tension, the door Testament not lasting properly. Whether the spring-loaded hinge applies extremely yet tension, the door Testament slam shut. Adjust the tension in a spring-loaded door hinge for Correct closing without slamming.
