Owners of some cars are inconvenienced by individual vitality able to airy their Timber with a explanation. No distrust, many would liking the convenience of existence able to pop agape the Timber from the Chauffeur's seat. This can be done by the Appendix of a solenoid. A solenoid is a Engine or ponderous labour actuator that pulls.7. Loop the cable that comes with the solenoid through the hole and back to the solenoid. Connect the cable into a special connector on the solenoid.8.
Capture the closest tools and materials: solenoid (which can be purchased from a vehivle stereo shop), 12-gauge electrical wire, a fuse, fuse holder, drill, Phillips screwdriver, accepted screwdriver, stripper, crimp connections, and a voltmeter. Consult the directions as to the bigness of the fuse you essential to get.
2. Glance at the tome that comes with the solenoid.
The Installation
3. Establish the Timber's guide Proceeds mechanism. It is commonly on the target of the van below the Timber lid when the lid is down.
4. Remove the panel that covers the mechanism.
5. Bonanza a purpose near the mechanism where the solenoid can be mounted securely. You appetite a metal surface, not a plastic one. Constitute decided that the stop is brisk enough to the release mechanism so that a cable can be looped to the mechanism and back to the solenoid.
6. Drill a little hole into the release mechanism.
When installed properly it can pull the instruction Proceeds mechanism of the Timber.
Instructions
Before the Installation
1.Test the solenoid to see if it works the release mechanism. You do this by taking a 9-volt battery and touching its terminals to the power line of the solenoid.
9. Make certain that you can still release the trunk using the key.
10. Run the trigger wire to the front of the vehicle where the driver sits.
11. Mount the switch that comes with the solenoid to a location on or under the dash that is easily accessible from the driver's seat.
12. Connect the trigger wire to the switch and connect the power wire from the switch to the fuse block so that it receives constant power. You can use the fuse for the cigarette lighter to serve as the constant power source. This means that you can use the switch to open the trunk when the car's ignition is off. Ground the solenoid and the switch.
