When you exchange the top radiator hose and convert the backside hose.
Over generation, the radiator hose on a Dodge Durango must be replaced seeing the fixed heating and cooling cycle of an engine Testament author the hose to weaken and dry-rot. Provided the hose cracks, the Durango Testament overheat and sanction you sitting helplessly on the side of the course. When replacing the upper radiator hose it is big-league to again silver the backside radiator hose. Although this Testament causation additional occupation and date, the mark aftereffect Testament be a stronger cooling development that you can depend on to amass that big SUV going down the course of action.
Instructions
Top Radiator Hose
1. Remove the coercion clamp that holds the top radiator hose onto the radiator hose. There are two tangs on the clamp that when squeezed well-balanced Proceeds the clamping impulse on the hose. Slide the clamp also onto the hose and then pull the hose off the radiator intake Harbour.
2. Fix the other confine of the radiator hose and remove the clamp that holds the radiator hose onto the intake tube of the thermostat housing. The clamp works in the corresponding action as the clamp that secured the hose to the radiator. Pull the hose off the thermostat intake tube.
3. Dwelling two band clamps onto the virgin radiator hose. Push one site of the hose onto the intake tube of the thermostat housing and then push the other boundary of the hose onto the intake Harbour of the radiator. Secure both clamps by turning the cam screw clockwise with a screwdriver.
Lower Radiator Hose
4. Guide the Durango onto a allot of front-end ramps To admit clearance under the vehicle to bleed the radiator. Pull the radiator hose off the outtake port and allow any excess fluid in the hose to drain into the bucket.7. Locate the lower fluid intake on the engine block. The radiator hose connects to it.
Place the petcock, or empty, that is located on the backside of the radiator. Country a bucket under the petcock and turn the valve counterclockwise. Confess all of the radiator fluid to void into the bucket.
6. Remove the clamp that secures the lower radiator hose to the outtake Harbour. The clamp works in the same manner as the clamps used on the upper radiator hose. Secure the vehicle by pulling the emergency brake. This keeps the vehicle from backing off the ramps while you are under it.5.
Remove the clamp that secures it and pull the hose off the intake. Again, the same clamp is used to secure this hose.
8. Place two band clamps on the new lower radiator hose. Place one end of the hose onto the intake (located on the engine block) and then place the other end of the hose onto the outtake port of the radiator.
9. Place two band clamps on the new lower radiator hose. Place one end of the hose onto the intake (located on the engine block) and then place the other end of the hose onto the outtake port of the radiator.
10. Secure both band clamps by turning the cam screw clockwise.
11. Open the radiator filler cap and drain the bucket of radiator fluid back into the radiator or fill using new radiator fluid.
