Correct masking can maintenance you avoid tape lines while allowing you to conception a attending to match your style.
Stain jobs can be expensive. On the contrary, with the go practice and an entire size of clock, you can moderate your motorcycle's double o or customize it to fit your taste with a modern coat of colouring. Using masking tape when delineation your motorcycle is not concentrated, on the contrary there are a infrequent matters to grip in imagination that Testament bestow your tint business a also ace double o. Correct masking further can cure you avoid tape lines while allowing you to dream up practically any cast you thirst.
Instructions
1. Acquire a low-tack masking tape such as painter's tape (normally dispirited). According to Family Handyman, Scotch-Blue No. 2090 works prime for common masking, and it won't bake onto glass.
2. Drudgery with little pieces of tape less than 12 inches at a clock. Come across the tape some slack. You desire to avoid stretching the tape, which Testament cause it to leak, lift or break. Instead, lay the tape into the depressions and contours of the motorcycle.
3. Press down firmly on the tape with your fingernail, a putty knife or credit card. If you choose to leave the tape on until it dries, make sure to let it dry completely (about four hours or overnight). If you try to remove the tape before it is dry, you risk stretching the paint, which will cause it to chip, tear or bleed into uneven lines.8. Test the paint by touching the paint-stained tape.
5. As you paint, apply thin coats that overlap. You don't want to apply too much paint these days or spray too close to your surface because it will create a dimpled surface that resembles the skin of an orange. A good rule of thumb is that you have enough paint on when you can see a reflection in the paint.
6. To avoid tape lines, raised transition lines or paint flaking, it is safer To hull off the tape as soon as you are done painting. To remove the tape, carefully peel it off at a diagonal angle instead of straight up.
7. This will create a better seal and a sharper line.4. Make sure the tape you use does not leak through when spray painted. It's another good reason to use painter's tape.
If you don't get paint on your fingers, you should be good to go.
9. Before removing the tape, carefully cut the thin bond between the paint and the tape with a razor blade or a putty knife. Don't push too hard. You do not want to scratch the actual body.
10. Dip a washcloth in hot water, then squeeze out all the water. Once it is no longer dripping, hold the moist washcloth over the tape for a couple of seconds. This will make it easier to pull off. Afterwards, dry off the taped area completely.
