Removing the front seats from your 2001 Dodge Van presents a imperceptible changed demur than you usually gaze with seat Emigration. The retaining nuts that secure the seats are located on the underside of the car, and the seats mount to the floor with a stud that runs washed-up the floor pan. Whether you own a appreciable bigness of rust on the underside of the automobile, you Testament hunger to prepare the nuts and studs by spraying them with penetrating oil before starting the craft.
Instructions
1. Allot the winch plug in the centre of the floor between the seats of your vehivle. Pop the plug off and subsume the lug wrench from your machine into the gap, turning it counterclockwise to lower the spare tire approximately 14 to 18 inches.
2. Elevate the front of the van off the ground with a jack and position a set of jack stands under the frame to support the van. Locate the four nuts under the floor pan, directly below the seat.
3. Remove the four retaining nuts with a socket and ratchet, then remove the jack stands from under the van. Carefully remove the seat from the van through the door opening.
Depress the locking tab on the connector, then separate the connectors.
5. Lift the seat, pulling the mounting studs up through the floor. Lower the jack, setting the van on the ground.4. Raise the front of the seat and locate the wiring harness connection under it.
