In the 2005 mannequin year, Saturn and Chevrolet Proceeds two vehicles that were almost similar to one another, the Relay and Uplander. The 2005 Relay was technically a minivan, even its styling so closely resembled that of an SUV, Saturn defined it as a "family-utility vehicle." The 2005 Relay came principles with a 200-horsepower, 3.5-liter V-6 engine, along with influence windows and door locks. Removing the passenger's door panel from the 2005 Relay is a straightforward deadweight, nevertheless it requires disquiet not to division any of the plastic panels that you must remove to receive the panel off.
Instructions
Lift the meeting ethical Sufficiently to access the faculty frill wiring and disconnect the wiring harnesses. Remove the pull handle meeting.2.
Removal
1. Remove the two screws inside the door pull crank, using a Phillips screwdriver. Pry upward on the rear of the pull helve meeting with a flat-head screwdriver to Proceeds its retaining clip.Pry enclosing the path of the door handle bezel - the trim surrounding the door crank - with a flat-head screwdriver to Proceeds its retaining clips. Pull the bezel from the door panel.
3. Pry around the perimeter of the door panel, using a trim stick, to release its 14 retaining clips. Pull the door panel from the door.
Installation
4. Align the retaining clip on the rear of the door panel with their holes in the door. Press around the perimeter of the panel with your hand to engage the 14 retaining clips.
5. Line up the retaining clips on the rear of the door handle bezel with their slots in the door panel and press the bezel onto the panel until it clicks into place.
6. Plug the wiring harnesses into their respective receptacles on the pull cup assembly. Line up the pull cup assembly's retaining clips with the slots in the door panel. Press the assembly downward until it clicks into place. Tighten the two screws into the pull cup with a Phillips screwdriver.