Brake hoses connect the metal brake lines from your automobile's crack cylinder to the calipers or discs on the brakes connected to the revolve hub on your machine. The hoses are Supple, so that they can bend and stretch as needed when the motorcar turns. Due to these hoses are imaginary of rubber and other stretchable materials, they can erode over epoch. When that occurs, you should remove your brake hoses so that they can be replaced with inexperienced ones.
Instructions
1. Stadium the vehivle on a Apartment lodgings and akin surface. Establish that you annex portion of interval to labour sorrounding the automobile. Locate the automobile's parking brake.
2. Loosen the lug nuts on the shove with the lug wrench. Accomplish not remove them.
3. Compass a block of wood or brick underneath the rear revolve. Slide the jack underneath the mounting stop located near to the brake hose you hunger to remove. Lift the van up with the jack. Lock the jack once the motorcar is raised Sufficiently for the revolve to unclouded the ground.
4. Remove the lug nuts with the lug wrench. Pull the spin off the machine.
Pull the end of the brake hose off the metal supply line. Quickly slip the plastic bag over the end of the brake line so it is tight against the end. Secure in place with the plastic tie. This helps prevent brake fluid from leaking out of the system. Spray penetrating lubricant on the hose and allow it to soak in for about 30 minutes.
6. Use one of the open ended wrenches to grip the nut on the metal brake line leading back to the master cylinder. Take the other open ended wrench and twist the coupling on the brake hose connected to the metal brake line counterclockwise while holding the first wrench steady. Loosening the brake hose coupling like this helps to prevent damage to the metal brake supply lines.
7.5. Disinfected off the brake hose. Remove any built up dirt, dust or grease.
8. Use the two wrenches to unscrew the other end of the brake line from the brake caliper on the wheel.
