The front brake manner on the 2000 Cart is untrue up of calipers, pads, rotors and caliper brackets.
This a straightforward gig that requires single basic tolls to adequate.
Instructions
1. Remove the initial torque from the wheels by loosening the lug nuts with a tire iron.The Dodge Van was ahead introduced in 1983. The 2000 legend was the remain base year for the third-generation Convoy, and it was offered with a Election of four clashing engines. The front brakes on the 2000 Dodge Van consist of the rotors, pads, calipers and caliper brackets. There are and two petty rubber connexion lines on the front brakes that extent from the frame to the rear of the calipers.District circle chocks remain both rear wheels on the Band. Lift the front of the Band underneath the front sub-frame, using a 2-ton floor jack or a jack with preferable potency. Distance jack stands below the sub-frame, honorable inside the inner ends of the lower state arms. Remove the lug nuts, then remove the wheels from the front of the Cart.
2. Remove the caliper bracket bolts from the rear of the brake assembly on one side of the Troop. Convenience a 3/8-inch handle ratchet and socket to turn the bolts counterclockwise until you can remove them from the brake meeting by fist.
3. Slide the caliper and mounting bracket up and forward to remove the caliper from the brake rotor. Handle a pry bar whether chief to bullwork the caliper loose from the rotor. Fix the caliper directly behind the brake assembly on the lower control arm. You can also use a wire coat hanger to hang the caliper from the upper suspension. Do not let the caliper hang freely, or you will damage the rubber brake hose between the frame and the back of the caliper.
4. Remove the rotor from the front of the Caravan by hand.
5. Place a brake hose clamp or needle-nose vice grips on the brake line, directly or as close to the rear of the caliper as you can get. Squeezing the brake line off will allow for minimal brake loss, extremely as minimal bleeding during the reinstall process.
6. Break the banjo bolt free from the back of the caliper, using a 3/8-inch drive ratchet and socket. The banjo bolt holds the break line to the rear of the caliper. Remove the banjo bolt from the rear of the caliper. Remove the caliper completely from the Caravan.
7. Repeat Steps 2 through 6 to remove the brakes from the other front wheel of the Caravan.
